Abstract:Chloride-induced corrosion of reinforcement has been recognized as one of the most predominant causes of structural degradation. In this paper, experimental and numerical investigation was conducted to study the degraded shear performance of reinforced concrete beam. The corrosion of reinforcements, crack patterns, and structural behaviors of corroded specimens with various corrosion levels accelerated by the impressed current method were analyzed. The test results indicated that the corrosion-induced crack patterns have a close relationship with the level of reinforcement corrosion. Moreover, an obvious degradation of shear performance of corroded RC beams in terms of initial stiffness, cracking loads, ultimate bearing capacity, post-peak behavior, and energy dissipation capacity was observed, which became more pronounced as the corrosion level increased. When a severe corrosion level (eta(a) >= 12%) was encountered, the failure mode could even be changed from the shear-compression failure into a much more brittle diagonal splitting failure. In parallel, to numerically simulate the propagation of the main diagonal crack faithfully, the extended finite element method (XFEM) specified with an exponential softening traction-separation relationship was adopted. Moreover, to investigate the effect of corrosion-induced bond degradation, a user-defined element (UEL) was also developed to represent the interfacial bond response. The reasonable agreement between the numerical simulation and experimental results proved the feasibility of the proposed approach. (C) 2020 Elsevier Ltd. All rights reserved.

NUMERICAL INVESTIGATION OF SEVERELY CORRODED REINFORCED CONCRETE BEAMS

EXPERIMENTAL INVESTIGATION AND DESIGN OF SEVERELY CORRODED REINFORCED CONCRETE BEAMS

Residual strengths of reinforced concrete beams with heavy deterioration

Developing a Three-Dimensional Finite Element Analysis Approach to Simulate Corrosion-Induced Concrete Cracking in Reinforced Concrete Beams

Influence of Longitudinal Bar Corrosion on Impact Behavior of RC Beams

Corrosion-induced Shear Performance Degradation of Reinforced Concrete Beams

NONLINEAR ANALYSIS OF HEAVILY CORRODED REINFORCED CONCRETE BEAM

Deflection and Crack Calculation of Corroded Reinforced Concrete Beams

Shear Performance of Reinforced Concrete Beams with Corroded Stirrups in Chloride Environment

Study on Degradation Regularity of Bearing Capacity of RC Beams under Corrosive Conditions

Numerical investigation of corroded reinforced concrete exterior beam‐column joints under quasi‐static reverse cyclic loading

FINITE ELEMENT ANALYSIS OF COMPOSITE STEEL-CONCRETE BEAMS WITH STUD CORRODED

Performance of Reinforced Concrete Beams Corroded under Sustained Service Loads: A Comparative Study of Two Accelerated Corrosion Techniques

FLEXURAL CAPACITY OF CORROSION-DAMAGED RC BEAMS

Performance of Corroded Reinforced Concrete Columns under the Action of Eccentric Loads

Study on Mechanical Properties of Steel-Concrete Composite Beam with Corroded Studs Under the Effect of Negative Bending Moment

Mechanical Degradation of Reinforced Concrete Columns Corroded Under Sustained Loads

Experimental and Numerical Study on Ultimate Shear Load Carrying Capacity of Corroded RC Beams

Design of Shear Strengths of Corroded Reinforced Concrete Beams

Three-dimensional nonlinear finite element analysis of corroded reinforced concrete beams strengthened by CFRP sheets

BENDING RESISTANCE BEHAVIOR OF SEVERELY CORRODED REINFORCED CONCRETE BEAM