Abstract:Steel corrosion is a critical factor in the seismic performance degradation of prefabricated concrete structures. In this study, the constant current accelerated corrosion method was employed to achieve targeted corrosion levels in steel bars within prefabricated column-footing joints connected by a grouted splice sleeve (GSS). Following that, a quasi-static cyclic experiment and numerical simulation method were employed to investigate the seismic performance of the specimens under various corrosion levels. Seismic performance indicators of specimens including the hysteresis curves, skeleton curves, bearing capacity, ductility coefficient, stiffness, and cumulative energy dissipation are examined. The results demonstrate that the failure modes of all column-footing joints are flexural failures. Specimens with steel bar corrosion levels below 14.1 % show negligible impact on the seismic performance. However, as the corrosion level increases, both the bearing capacity and cumulative energy dissipation capacity of the specimens significantly decrease. The horizontal displacement and ultimate displacement corresponding to the maximum bearing capacity are only 50.5 % and 45.2 %, respectively, compared to the noncorroded specimen. Additionally, a refined finite element model of prefabricated columnfooting joints with GSS connections under different corrosion levels is developed and the hysteresis and skeleton curves obtained by numerical simulation are verified to be in good agreement with the experimental results. The numerical simulation outcomes regarding peak load and corresponding horizontal displacement maintain a relative error within 15 % compared to the experimental results.

Numerical investigation of corroded reinforced concrete exterior beam‐column joints under quasi‐static reverse cyclic loading

NUMERICAL INVESTIGATION OF SEVERELY CORRODED REINFORCED CONCRETE BEAMS

Developing a Three-Dimensional Finite Element Analysis Approach to Simulate Corrosion-Induced Concrete Cracking in Reinforced Concrete Beams

Seismic performance of exterior reinforced concrete beam-column joint with corroded reinforcement

Evaluation of corrosion morphology on mechanical properties of reinforcing steel bars using numerical simulation and simplified analytical model

Residual strengths of reinforced concrete beams with heavy deterioration

Mechanical Degradation of Reinforced Concrete Columns Corroded Under Sustained Loads

Corrosion-induced Shear Performance Degradation of Reinforced Concrete Beams

EXPERIMENTAL INVESTIGATION AND DESIGN OF SEVERELY CORRODED REINFORCED CONCRETE BEAMS

Seismic Behaviour of Exterior Beam-Column Joint Using Steel Fibre-Reinforced Concrete Under Reverse Cyclic Loading

Effects of Reinforcement Corrosion and Sustained Load on Mechanical Behavior of Reinforced Concrete Columns.

Seismic Performance of Corroded Prefabricated Column-Footing Joint with Grouted Splice Sleeve Connection: Experiment and Simulation

Study on Degradation Regularity of Bearing Capacity of RC Beams under Corrosive Conditions

Analytical Model for Concrete Jacketed RC Columns with Precorrosion and Postcorrosion Damages under Uniaxial Loading

Performance of Corroded Reinforced Concrete Columns under the Action of Eccentric Loads

Numerical Modelling of Seismic Behaviour of an Exterior RC Beam Column Joint Strengthened with UHPFRC and CFRP

Performance of Reinforced Concrete Beams Corroded under Sustained Service Loads: A Comparative Study of Two Accelerated Corrosion Techniques

Axial Loading Capacity Of Concrete-Jacketed Rc Columns With Pre- And Post-Corrosion Damage

Compressive Behaviour of Corroded Thin-Walled Circular Section Steel Stub Columns

Deflection and Crack Calculation of Corroded Reinforced Concrete Beams

A Numerical Study on the Influence of Bolt Corrosion on the Long-Term Behavior of Steel–Concrete Composite Beams