Abstract:Electrochemical etching of silicon carbide (SiC) material has received increasing attention in recent years, due to its simple procedure, low cost and significance in the exploration of novel optoelectronic devices. In this paper, 4H-SiC substrates were electrochemically etched at a constant current density of 392.98 mA cm-2 in an electrolyte made up of hydrofluoric acid and deionized water. The layering of a SiC porous layer and periodic fluctuation of the voltage were witnessed for the first time, with the layering phenomenon corresponding well to the voltage period. However, no such phenomenon was observed when the SiC substrates were anodic etched under the same conditions with magnet stirring. As a result, the periodic variation of voltage was hypothesized to be the cause of regular layering during constant current electrochemical etching. Electrochemical etching in potentiostatic mode was thus performed at different voltages. We found that the diameter of the SiC nanopores increased while the thickness of the sidewall decreased with the increasing voltage. Based on the experimental findings, a model of mass transport was proposed. The mass transport process leads to periodic changes in resistance, hence the periodic change in voltage. This successfully explained the reason for the layering. Furthermore, SiC substrates were also electrochemically etched at high and low current densities, finding the existence of a threshold current density for the occurrence of the layering. Energy dispersive x-ray spectroscopy analysis showed that the composition of the SiC porous layer remained unchanged compared to the pure SiC wafer, implying that the peeling-off of the SiC porous layer obtained by electrochemical etching can be directly adopted for use on devices requiring a SiC porous structure.

Revealing the Nanodomain Structure of Silicon Oxycarbide Via Preferential Etching and Pore Analysis

Chemical Structure and Microstructure Characterization of Ladder-Like Silsesquioxanes Derived Porous Silicon Oxycarbide Materials

Fabrication of in Situ Ultrathin Anodic Aluminum Oxide Layers for Nanostructuring on Silicon Substrate

Core‐shell SiC/SiO2 Heterostructures in Nanowires

Study on the layering phenomenon of SiC porous layer fabricated by constant current electrochemical etching

Effect of HF and NaOH Etching on Chemical and Structure Stability of Hollow SiOC Ceramics

Hydrogen Bubbles and Formation of Nanoporous Silicon During Electrochemical Etching

Manipulation Of Phase And Microstructure At Nanoscale For Sic In Molten Salt Synthesis

Construction of EG/SiOC@C porous structure by direct ink writing and in-situ vapor self - Deposition to enhance microwave absorption

Silicon Oxycarbide/Carbon Nanohybrids with Tiny Silicon Oxycarbide Particles Embedded in Free Carbon Matrix Based on Photoactive Dental Methacrylates.

Effect of silicon resistivity on its porosification using metal induced chemical etching

XPS Analysis of Silicon Oxycarbide Formed on the Surface of Rf-Sputter Deposited SiC Thin Films

Template-free Synthesis of Hierarchically Porous SiBCN Monolith from Organic Gel Precursors

Novel 0D-nanocarbon-silica ceramic composites: sol-gel synthesis and high-temperature evolution

Investigation on femtosecond laser combined with dynamic wet etching machining of SiC/SiC

Hierarchical Nanostructuring of Porous Silicon with Electrochemical and Regenerative Electroless Etching

High Aspect Ratio Etching of Nanopores in PECVD SiC Through AAO Mask

Thermal evaporation and solution strategies to novel nanoarchitectures of silicon carbide

SiOC Phase Control and Carbon Nanoribbon Growth by Introducing Oxygen at Atom Level for Lithium‐Ion Batteries

Preparation of Hierarchical Porous Silicon Carbide Monoliths via Ambient Pressure Drying Sol–Gel Process Followed by High-Temperature Pyrolysis

Growth of Single-Walled Carbon Nanotubes on Porous Silicon