Abstract:Amorphous polymer-derived silicon oxycarbide (SiOC) is an attractive candidate for Li-ion battery anodes, as an alternative to graphite, which is limited to a theoretical capacity of 372 mAh/g. However, SiOC tends to exhibit poor transport properties and cycling performance as a result of sparsely distributed carbon clusters and inefficient active sites. To overcome these limitations, we designed and fabricated a layered graphene/SiOC heterostructure by solvent-assisted infiltration of a polymeric precursor into a modified three-dimensional (3D) graphene aerogel skeleton. The use of a high-melting-point solvent facilitated the precursor's freeze drying, which following pyrolysis yielded SiOC as a layer supported on the surface of nitrogen-doped reduced graphene oxide aerogels. The fabrication method employed here modifies the composition and microstructure of the SiOC phase. Among the studied materials, the highest levels of performance were obtained for a sample of moderate SiOC content, in which the graphene network constituted 19.8 wt % of the system. In these materials, a stable reversible charge capacity of 751 mAh/g was achieved at low charge rates. At high charge rates of 1480 mA/g, the capacity retention was ∼95% (352 mAh/g) after 1000 consecutive cycles. At all rates, Coulombic efficiencies >99% were maintained following the first cycle. Performance across all indicators was majorly improved in the graphene aerogel/SiOC nanocomposites, compared with unsupported SiOC. The performance was attributed to mechanisms across multiple length scales. The presence of oxygen-rich SiO4–xCx tetrahedral units and a continuous free-carbon network within the SiOC provides sites for reversible lithiation, while high ionic and electronic transport is provided by the layered graphene/SiOC heterostructure.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.0c12376?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.0c12376</a>.Further graphics relating to the macrostructure, microstructure, composition, and performance of materials fabricated in the present work, and tables providing a comprehensive comparison of the conductivity and cycling performance of anode materials studied here with related studies reported in the literature (<a class="ext-link" href="/doi/suppl/10.1021/acsami.0c12376/suppl_file/am0c12376_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

SiOC Phase Control and Carbon Nanoribbon Growth by Introducing Oxygen at Atom Level for Lithium‐Ion Batteries

Simultaneously Manipulating Carbon Coating Layers and Void Structures in Silicon/Carbon Anode Materials Via Bifunctional Templates for Lithium-Ion Batteries

Lithiation of SiO2 in Li-ion Batteries: in Situ Transmission Electron Microscopy Experiments and Theoretical Studies.

Dual‐Carbon Phase‐Encapsulated Prelithiated SiOx Microrod Anode for Lithium‐Ion Batteries

Sequencing-Dependent Impact of Carbon Coating on Microstructure Evolution and Electrochemical Performance of Pre-lithiated SiO Anodes: Enhanced Efficiency and Stability via Pre-Coating Strategy

Modulation of Free Carbon Structures in Polysiloxane-Derived Ceramics for Anode Materials in Lithium-Ion Batteries

Boosting the initial coulombic efficiency for SiO anodes through component controlling and microcrystalline size limiting regulated by carbon layer

Carbon-enriched SiOC ceramics with hierarchical porous structure as anodes for lithium storage

Chemical Pre-lithiation of SiO x Anodes with a Weakly Solvating Solution of Polycyclic Aromatic Hydrocarbons for Lithium-Ion Batteries

Li-Si alloy pre-lithiated silicon suboxide anode constructing a stable multiphase lithium silicate layer promoting Ion-transfer kinetics

Controlled Prelithiation of Silicon Monoxide for High Performance Lithium-Ion Rechargeable Full Cells

Asphalt-based Carbon Boosts the Cyclability and Rate Capability of SiOC Anode for High-Performance Lithium Ion Batteries

Engineering Si-Based Anode Materials with Homogeneous Distribution of SiO x and Carbon for Lithium-Ion Batteries

Polymer-Derived SiOC Integrated with a Graphene Aerogel As a Highly Stable Li-Ion Battery Anode

Rational Design of Si@Carbon with Robust Hierarchically Porous Custard-Apple-Like Structure to Boost Lithium Storage

A nanostructured Si/SiOC composite anode with volume-change-buffering microstructure for lithium ion batteries.

Effective disproportionation of SiO induced by Na2CO3 and improved cycling stability via PDA-based carbon coating as anode materials for Li-ion batteries

Highly Graphitized Carbon Coating on SiO with a π–π Stacking Precursor Polymer for High Performance Lithium-Ion Batteries

A Hierarchical Si/C Nanocomposite of Stable Conductive Network Formed Through Thermal Phase Separation of Asphaltenes for High-Performance Li-Ion Batteries

Pre-lithiation synergized with magnesiothermic reduction to enhance the performance of SiO anode for advanced lithium-ion batteries

SiOC Nanolayers Directly-Embedded in Graphite As Stable Anode for High-Rate Lithium Ion Batteries