Abstract:In this study, the in situ 4 wt.% TiB 2(p) /Al-Cu composite was prepared through a mixed salt reaction method. To evaluate its formability, hot isothermal compression tests were performed using a Gleeble−3500 system in a temperature range of 480-510 °C and a strain rate range of 0.1-10 s −1 . A constitutive model of the composites with strain compensation was established, and the true stress–strain curves revealed that the composite exhibited favorable formability at 510 °C. Additionally, single-pass equal channel angular pressing (ECAP) processes were conducted at room temperature and 510 °C to investigate the microstructure evolution of the composite. The distribution of TiB 2 particles was found to be influenced by deformation temperature, while the microstructural characteristics of the aluminum matrix were minimally affected. Furthermore, a comparison between the as-cast composite and the deformed composites revealed the presence of different preferred orientations in the two conditions, and the corresponding paths of texture evolution were estimated accordingly. Remarkably, after undergoing single-pass ECAP, the Schmid factors of composites remained nearly unchanged, demonstrating that deformed composites were still appropriate for processing and as such demonstrating a potential route also for formability assessment.

Microstructure and Mechanical Property of an Ecap Processed Al-Mg2si in Situ Composite by Using A Combined Route

Microstructure and Mechanical Property of the Ecaped Mg2si/Mg Composite

Microstructure and mechanical properties of AlMgSi alloys after equal channel angular pressing at room temperature

Microstructural evolution and mechanical response of duplex Mg-Li alloy containing particles during ECAP processing

Microstructure Evolution and Mechanical Properties of Nano-Sicp/Az91 Composite Processed by Extrusion and Equal Channel Angular Pressing (Ecap)

Effect of Equal Channel Angular Pressing on the Microstructure Evolution Andmechanical Property of the SiCP/AZ91 Composite Fabricated by Stir-Casting

Microstructural evolution and mechanical properties of AZ31 Mg alloy fabricated by a novel bifurcation-equal channel angular pressing

Mechanical And Microstructure Evaluation Of In-Situ Titanium Matrix Composite Processed By Severe Plastic Deformation

Microstructure and Mechanical Properties of Mg96Y3Zn1 Alloy Processed by Equal Channel Angular Pressing

The Microstructure and Mechanical Properties of AZ31 Mg Alloy Processed by Two-Step Equal Channel Angular Extrusion

Microstructure and mechanical properties of AZ31 Mg alloy processed by two-step equal channel angular extrusion

Preparation and Mechanical Properties of in Situ Submicron MgAl2O4p/6061Al Composites from Al–Mg–SiO2 System

Microstructure and Mechanical Properties of Ultrafine Grained Mg97Y2Zn1 Alloy Processed by Equal Channel Angular Pressing

Improved Microstructure and Mechanical Properties of AZ31–Mg2Si in Situ Composite Fabricated by Cyclic Closed-die Forging

Mechanical Properties and Microstructure of AZ31 Mg Alloy Processed by Two-Step Equal Channel Angular Extrusion

Enhancing mechanical properties and microstructure evolution of hybrid AZ61-5SiC-0.5CNTs composite during equal channel angular pressing

Mg-Al-Ca In-Situ Composites with a Refined Eutectic Structure and Their Compressive Properties

Preliminary Investigations on the Mg–Al–Zn/Al Laminated Composite Fabricated by Equal Channel Angular Extrusion

Preparing Mg-6Al alloy with high mechanical properties and fine grains by equal channel angular extrusion

Electron Backscatter Diffraction Investigation on Microstructure Evolution of TiB2(p)/Al-Cu Composite after Single-Pass Equal Channel Angular Pressing for Formability Assessment

Microstructure and Mechanical Properties of Mg–Zn–Ca Alloy Processed by Equal Channel Angular Pressing