Abstract:The correlation between the microstructure and the deformation behavior of AZ31 alloys processed by as-extrusion and equal channel angular extrusion(ECAE) was investigated.The results show that there is a reverse Hall-Petch relationship between the yield stress and the grain size of ECAE AZ31 Mg alloy,and the tension-compression asymmetry is weakened;ECAE alloy also exhibits a strain rate sensitivity,and the strain rate sensitivity factor will be increased with increasing the process temperature.The average grain size is 20 μm for the as-extruded alloy with a typical ring basal texture,and the main deformation models at room temperature are basal slip and twinning,which result in the strong tension-compression asymmetry.The average grain size is about 2 μm for ECAE Mg alloy with a texture randomized relatively,which results in remarkably a decrease of twin volume fraction under compression loading,and then the tension-compression asymmetry in ECAE AZ31 alloy is weakened.The calculated apparent activation energy in the ECAE Mg AZ31 is approached to the activation energy of grain boundary diffusion Mg alloy,which provides an evidence to support that the deformation on grain boundaries plays an important role on the deformation behavior,and the possible grain boundary sliding(GBS) has contribution to the reverse Hall-Petch relationship and strain rate sensitivity in ECAE Mg alloy.

Microstructure and mechanical properties of AZ31 Mg alloy processed by two-step equal channel angular extrusion

The Microstructure and Mechanical Properties of AZ31 Mg Alloy Processed by Two-Step Equal Channel Angular Extrusion

Mechanical Properties and Microstructure of AZ31 Mg Alloy Processed by Two-Step Equal Channel Angular Extrusion

Microstructure Evolution and Mechanical Properties of AZ 31 Mg Alloy Processed by Equal Channel Angular Extrusion

Effect of Equal Channel Angular Extrusion on the Microstructure and Mechanical Properties of AZ31 Magnesium Alloy

Microstructure and Mechanical Properties of Magnesium Alloy AZ31 Processed by Compound Channel Extrusion

Microstructure Evolution of AZ31 Mg Alloy During Equal Channel Angular Extrusion

Preparing Mg-6Al alloy with high mechanical properties and fine grains by equal channel angular extrusion

A Study of Microstructure Evolution for Mg Alloy Subjecting to Multi-Pass Equal Channel Angular Extrusion

An Electron Back-Scattered Diffraction Study on the Microstructure Evolution of AZ31 Mg Alloy During Equal Channel Angular Extrusion

Influence of Equal Channel Angular Extrusion on the Properties of Mg-6Al Alloy

Change-Channel Angular Extrusion of Magnesium Alloy Az31

Microstructure and Mechanical Properties of AZ31 Mg Alloy Processed by Equal Channel Angular Pressing (ECAP)

The effect of texture on the mechanical properties of AZ31 MG alloy by equal channel angular extrusion

Deformation Behaviors of AZ31 Magnesium Alloy by Equal Channel Angular Extrusion

Microstructural evolution and mechanical properties of AZ31 Mg alloy fabricated by a novel bifurcation-equal channel angular pressing

Microstructure and Mechanical Properties of AZ31 Mg Alloy after Dual-Directional Extrusion

Effects of Die Angle on Microstructures and Mechanical Properties of AZ31 Magnesium Alloy Processed by Equal Channel Angular Pressing

Effect of Solution Treatment on Microstructure Evolution and Mechanical Properties of Mg-6.0Zn-0.6Y-0.5Zr Alloy Processed by Equal Channel Angular Extrusion

Effect Of Eche Forming On The Microstructure And Mechanical Properties Of Az31 Magnesium Alloy

Microstructure and mechanical properties of AZ31 alloy prepared by cyclic expansion extrusion with asymmetrical extrusion cavity