Abstract:Synthesis of nanocomposites is challenging due to the difficulties in achieving homogeneous distribution of reinforcing particles in metal. In this paper, an in‐situ Al‐MgAl2O4 nanocomposite billet was prepared by the reaction of ɣ‐Al2O3 with molten Al and ultrasonication‐assisted impeller mixing. The microstructure of the composite showed homogeneously distributed MgAl2O4 crystals alongside their clusters in the Al matrix. Microstructural analysis revealed MgAl2O4 crystals distributed from 20 nm to 4 μm in size. The hardness was found to vary within the composite from 50 Hv for the matrix to 140 Hv for particle cluster regions. The grain size was reduced from 1000 μm in reference metal (CP Al) to 100 μm in the composite. The compression strength of the composite was increased substantially and higher strain hardening effect in comparison with Al was noticed in the compression test. The signatures of extensive plastic deformation such as dislocation pileups, deformed grains, grain boundary pinning etc. were observed in the composite via transmission electron microscopy. Damping properties of as‐cast composite were higher than those of CP Al in the temperature range from room temperature to 350 °C. After rolling the composite up to 40% reduction, the damping capacity (Tanδ) of the composite was found to increase marginally after 150 °C. Higher damping was found to reoccur after the annealing treatment of the composite. The improvement in damping capacity at RT was possibly influenced by the micron sized MgAl2O4 and at higher temperatures by the nano‐sized MgAl2O4 crystals. The reoccurrence of higher damping in the annealed composite underlined the stability of finer grains due to the grain boundary pinning by nano‐sized MgAl2O4 crystals. The studies on the damping property of the composite displayed the benefits of having dual size distribution of MgAl2O4 crystals (nm and μm) in the composite. This article is protected by copyright. All rights reserved.

Preparation and Mechanical Properties of in Situ Submicron MgAl2O4p/6061Al Composites from Al–Mg–SiO2 System

MMCs with Controlled Non-Uniform Distribution of Submicrometre Al2O3particles in 6061 Aluminium Alloy Matrix

Microstructure and Mechanical Properties of In-Situ Α-Al2o3p/al-12si Composites Fabricated by Direct Melt Reaction Method with Aid of Electromagnetic Stirring

Study on Microstructure and Tensile Property of Sub-micron MgAl2O4(p)Al-Mg-Si Composite

In situ fabrication and microstructure of Al2O3 particles reinforced aluminum matrix composites

Microstructural characteristic and mechanical properties of the in-situ MgAl2O4 reinforced Al matrix composite based on Al-Mg-ZnO system

Foamability and mechanical properties of in situ submicron MgAl2O4p/Al composite foams by ultrasonic method

Microstructural evolution and property evaluation of in‐situ Al‐MgAl2O4 nanocomposite prepared by ɣ‐Al2O3 and ultrasonication‐assisted impeller mixing

Microstructures and Mechanical Properties of in Situ Al 2 O 3 /Al-Si Composites Fabricated by Reaction Hot Pressing

Microstructure and properties of in situ generated MgAl2O4 spinel whisker reinforced aluminum matrix composites

Microstructure and Mechanical Properties of In-Situ Nano Γ-Al2o3p/a356 Aluminum Matrix Composite

Enhanced Combination of Strength and Ductility in Ultrafine-Grained Aluminum Composites Reinforced with High Content Intragranular Nanoparticles

Analysis of Properties for in Situ Al(2)O(3)p/A356 Composites Synthesised from the Al-SiO2 System

Influence of characteristic parameters of SiC reinforcements on mechanical properties of AlSi10Mg matrix composites by powder metallurgy

In–situ synthesis of an Al composite reinforced with multi–scale Al12Mo, (Al, Zr, Si) and Al2O3 particles through a multi–stage reaction

Microstructure and Mechanism of In-Situ Al2o3(P)/Al Nano-Composites Synthesized by Sonochemistry Melt Reaction

In Situ （mg2si＋mgo）/mg Composites Fabricated from AZ91-Al2（SiO3）3 with Assistance of High-Energy Ultrasonic Field

In-situ fabrication of submicron alpha-Al2O3 particle reinforced AlSi9Cu3 alloy matrix composites by TIG arc process

Microstructure and Performance of Nanometer Γ-Al2o3p/al Composite Fabricated in Al-Co3O4 Components

In-Situ Fabrication And Properties Of Mg2si/Az91d Magnesium Matrix Composites

Microstructure and Mechanical Properties of High Strength Al2o3p/6061al Composites