Abstract:The traditional condition monitoring (CM) methods for power electronic devices are normally using electrical, magnetic, and thermal sensors. Alternatively, this paper uses the acoustic emission (AE) sensor to measure the mechanical stress wave generated inside the power electronic devices such as MOSFETs. Specifically, this paper focuses on the influence of measured surface, electrical parameters, and filters on the stress wave signal and the reliability of repeatability tests. Under the single pulse test with 300V drain-source voltage ( ${V}_{\text {ds}}$ ), the same acoustic emission sensor is pasted on the MOSFET package and the cooling surface with a coupling agent. The factors affecting stress waves are studied by changing electrical parameters and filters. The proposed experiments draw the following conclusions. 1) The characteristic parameters of the stress wave measured on the package and cooling surface of MOSFET are different under the same electrical parameters. 2) The characteristic parameters of the stress wave are almost unchanged under the same test conditions, which shows that the stress wave measurement method is reliable. 3) The peak value of the stress wave, the frequency domain amplitude, and energy are affected by ${V}_{\text {ds}}$ and turn-on time ( ${t}_{\text {on}}$ ). Specifically, the gate voltage ${V}_{\text {gs}}$ has no obvious trend to the amplitude. The impact on package is basically the same as the cooling surface.

Study On A New Method Of Applying External Stress To Mos Device

Mechanical Strain Altered Gate and Substrate Currents in N and P-Channel MOSFETs

Study of Local Stress Using Stress-Absorbing Si Diaphragm

Electrothermal-Stress Interactions of LDMOS FET Induced by DCI RF-Pulses

On-resistance reduction in vertical double diffusion metal oxide semiconductor devices using stress applied by thin film

A Novel Approach to Study Patterned Thin Film Local Stress for Microelectronics Application

Comprehensive study of the impact of TSV induced thermo-mechanical stress on 3D IC device performance

The Stress Distribution and Influence of VDMOS Device Based on ANSYS

Study of techniques for measuring residual stress in micromachined films

Back-Side Stress to Ease p-MOSFET Degradation on e-MRAM Chips

Impact of TSV Induced Thermo-Mechanical Stress on Semiconductor Device Performance

Optimization of magnetoimpedance and stress-impedance effects in single-microwire polymer composites for stress monitoring

Stress Impact of the Annealing Procedure of Cu-Filled TSV Packaging on the Performance of Nano-Scaled MOSFETs Evaluated by an Analytical Solution and FEA-Based Submodeling Technique

Comparative study of mechanical stress-induced flat-band voltage change in MOS capacitor and threshold voltage change in MOSFET fabricated on 4H-SiC (0001)

Study on Extraction of Stress-Induced Interface Traps in MOSFETs by Linear Cofactor Differernce Subthreshold Voltage Peak Technique

A stress concentration MOSFET structure

A Method of Studying the Effect of Stress and Thermal-stress Coupling on the Thermal Conductivity of the Film

Investigation of the Degradation Mechanism of SiC MOSFET Subjected to Multiple Stresses

Analysis of the Stress-Wave Influence Parameters of Silicon MOSFET under 300V Drain Source Voltage

New Methods for Measuring Mechanical Properties of Thin Films in Micromachining: Beam Pull-in Voltage (VPI) Method and Long Beam Deflection (LBD) Method

Influence of contact positioning on the performance of stress induced MOSFETs