Abstract:In off-axis subapertures of most convex aspheres, astigmatism and coma dominate the aberrations with approximately quadratic and linear increase as the off-axis distance increases. A pair of counter-rotating computer generated hologram (CGH) plates is proposed to generate variable amount of Zernike terms Z4 and Z6, correcting most of the astigmatism and coma for subapertures located at different positions on surfaces of various aspheric shapes. The residual subaperture aberrations are then reduced within the vertical range of measurement of the interferometer, which enables near-null test of aspheres flexibly. The alignment tolerances for the near-null optics are given with optomechanical analysis. Accordingly a novel design for mounting and aligning the CGH plates is proposed which employs three concentric rigid rings. The CGH plate is mounted in the inner ring which is supported by two couples of ball-end screws in connection with the middle ring. The CGH plate along with the inner ring is hence able to be translated in X-axis and tipped by adjusting the screws. Similarly the middle ring is able to be translated in Y-axis and tilted by another two couples of screws orthogonally arranged and connected to the outer ring. This design is featured by the large center-through hole, compact size and capability of four degrees-of-freedom alignment (lateral shift and tip-tilt). It reduces the height measured in the direction of optical axis as much as possible, which is particularly advantageous for near-null test of convex aspheres. The CGH mounts are then mounted on a pair of center-through tables realizing counter-rotation. Alignment of the interferometer, the CGHs, the tables and the test surface is also discussed with a reasonable layout of the whole test system. The interferometer and the near-null optics are translated by a three-axis stage while the test mirror is rotated and tilted by two rotary tables. Experimental results are finally given to show the near-null subaperture test capability of the system for a convex even asphere.

Absolutely Testing of Off-Axis Aspherical Mirror Using Dichotomy Computer-Generated Holograms

Absolute Testing of Rotationally Symmetric Surfaces with Computer-Generated Holograms

Study on testing larger asphericity in non-null interferometer - art. no. 68340T

Using Computer-Generated Holograms to Test Cubic Surface

Problems on Design of Computer-Generated Holograms for Testing Aspheric Surfaces: Principle and Calculation

Research on hybrid compensation testing of convex aspherical mirror

Sub-Aperture Stitching Test Of A Cylindrical Mirror With Large Aperture

Testing an Aspheric Mirror Based on Phase Measuring Deflectometry

Null Test of Aspheric Surface Based on Digital Phase-Shift Interferometer

Measurement of Convex Aspheric Lens' Optical Performance Using Computer-Generated Holograms

Mixed compensation for the testing of large convex aspheres

New Design Techniques and Alignment Methods for Cgh-Null Testing of Aspheric Surface

Problems on Fabrication of Computer-Generated Holograms for Testing Aspheric Surfaces

Distance Deviation Sensitivity on Null Test of Convex Hyperboloid Mirrors with Large Relative Aperture

Optomechanical Design of Near-Null Subaperture Test System Based on Counter-Rotating CGH Plates

Practical and Accurate Method for Aspheric Misalignment Aberrations Calibration in Non-Null Interferometric Testing

Subaperture Stitching Test for Large Aperture Mild Acylinders

Aspheric Mirror Testing with Phase Retrieval Method

The Method to Reduce the Spinal Error in the Aspheric Mirror Testing with the Cgh

Computer-aided alignment in null testing of large aspheric mirrors

Quasi-absolute Interferometric Testing of Cylinders.