Abstract:As to minimize size of the measurement system of large size and ultra-long focal length lens, two mirrors are used to change light path. In this case, installation error of the two mirrors added may be a large obstacle to accurate measurement of ultra-long focal length lens. For the sake of analyzing how installation error of two mirrors infect the angle of Moiré stripes on receiver, Moiré stripes are understood as parallel lines which composed of point light source with certain light-path vector. This approach proposed uses the calculation formula from mirror deflection angle to the reflector unit normal vector, and the matrix form of the law of reflection, to calculate the relationship matrix from vector of incident light to vector of exit light. Based on unit normal vector of two mirrors, incident light-path vector, exit light-path vector, and analytic geometry, equation of line on which image of point light source place can be presented, so we can get the angle of Moiré stripes on receiver and so is the angle error caused by installation error of the two mirrors added into light path. In addition, the angle error of Moiré stripes is calculated theoretically in 49 different situations of small mirrors deflection smaller than 1 degree. The results indicate that the installation error of the two mirrors should be taken into consideration. A new method by using autocollimator to adjust the installation error of the two mirrors is proposed, installation error of the two mirrors can be controlled to lower than 1" through this method. Moiré stripes angle error should be better than (10-4) order of magnitude in this situation. Experimental results show that Moiré stripes angle measurement error is 0.005 degree, which fully illustrates the effect of mirrors adjustment when this system is used for the measurement of ultra-long focal length.

Research on hybrid compensation testing of convex aspherical mirror

Mixed compensation for the testing of large convex aspheres

Hybrid Refractive and Diffractive Testing Method for Free-Form Convex Mirror in High-Resolution Remote-Sensing Cameras

Research of precision interference locating method for a partial null compensator at aspheric testing

Novel Algorithm for Compensating Misalignment in Optical Spherical Surface Testing

Non-null interferometric aspheric testing with partial null lens and reverse optimization

Analysis on mirrors installation error of high-accuracy long focal length measurement system

The wavefront aberration analysis and testing accuracy evaluation for the large aberration aspheric system based on the best fit sphere - art. no. 68342V

Study on testing larger asphericity in non-null interferometer - art. no. 68340T

Testing of Large-Aperture Aspheric Mirrors Using a Single Coated Lens.

The Wavefront Aberration Analysis and Testing Accuracy Evaluation for the Large Aberration Aspheric System Based on the Best Fit Sphere

Retrace Error Correction for Non-Null Testing of Optical Aspheric Surface

Testing of an off-axis convex hyperboloid mirror using compensator

Aspheric and Free-Form Surfaces Test with Non-Null Sub-Aperture Stitching

Non-null Testing of the Aspheric Surface Using a Quadriwave Lateral Shearing Interferometer

Measurement of Aspheric Surface

The Optimization of a Convex Aspheric Lightweight SiC Mirror and Its Optical Metrology

Simulation of Convex Aspherical Surface Testing with Partial Compensating Interferometer

Corrective machining of monolithic multiple freeform mirrors based on holographic null test

Using Computer-Generated Holograms to Test Cubic Surface

Practical and Accurate Method for Aspheric Misalignment Aberrations Calibration in Non-Null Interferometric Testing