Abstract:Metallic foams are considered as promising structural materials which can be used in a wide industrial domain such as lightweight structure design, impact energy absorption, acoustical wave attenuation, etc. The behaviour of these foams at high strain rates is therefore desired. However, the rate sensitivities of these foams are not well caracterisized because of experimental difficulties. Actually, commonly used testing technique such as classical Split Hopkinson Pressure Bar (SHPB) does not provide satisfactory results. If a classical SHPB system composed of small diameter steel bars (about 10mm) is used, an important impedance difference between bars and foam specimen or a small specimen size with respect to the cell size will result in a poor measuring accuracy. This paper presents a new testing device (a 60mm diameter nylon Hopkinson bar system) which provides an interesting solution of these deficiency. A closed outer-surface aluminium foams cylindrical specimen (4.5mm diameter and 60mm length) were tested in both common SHPB and block bar configuration. With the quasi-static tests, three groups of testing results are given for following loading speeds: 1 mm/min, 10m/s, 27m/s. Even though there are unavoidable scatters for this kind,of materials, the rate sensitivity is clearly observed. In addition, tests with rate jump on the same specimen (static loading after dynamic one or dynamic after static one) have been performed. It shows a discontinuity of stress-strain curve. This gives another proof that the material is rate sensitive in this range of loading rate.

Features of Meso-Deformation and Failure of Aluminum Foam under Impact

Meso deformation characteristics analysis ofaluminum foam under impact

Deformation and stress nonuniformity of aluminum foam under different impact speeds

The Deformation Measurement and Analysis on Meso-Structure of Aluminum Foams During Shpb Test

Localized deformation in aluminium foam during middle speed Hopkinson bar impact tests

Test of Aluminum Foam Deforming Process under Impact Load Based on Digital Image Correlation Method

Experimental investigation on the strain-rate effect and inertia effect of closed-cell aluminum foam subjected to dynamic loading

Temperature Effects on the Mechanical Behavior of Aluminum Foam under Dynamic Loading

Experimental and mesoscopic investigation of double-layer aluminum foam under impact loading

Mechanical Properties and Constitutive Model Applied to the High-Speed Impact of Aluminum Foam That Considers Its Meso-Structural Parameters.

Experimental Study of Aluminium Foams under Impact Loading

Deformation Process Study of Aluminum Foam at High Dynamic Temperature Based on SHPB

Parameter Study on Material Model of Aluminium Foams under Impact Load

Tracking and Analysis of Aluminum Foam Deformations in SHPB Experiment by Using High-speed Camera

Numerical Analysis on the Reliability of Characterizing Dynamic Mechanical Properties of Metal Foam by SHPB Test

Mechanism of the Strain Rate Effect of Metal Foams with Numerical Simulations of 3D Voronoi Foams During the Split Hopkinson Pressure Bar Tests

Deformation Characteristic of Metal Foam under Different Strain Rate and Temperature

Mechanical Simulation of the Localized Deformation in the Aluminum Foams: A Three-Dimensional (3d) Structure Based Study

Numerical Study of Dynamic Compression Process of Aluminum Foam with Material Point Method

Numerical Analysis on Usability of SHPB to Characterize Dynamic Stress–Strain Relation of Metal Foam

Shock Enhancement of Aluminum Foam under Impact Loading Using Fem Simulations