Abstract:Metallic foams are considered as promising structural materials which can be used in a wide industrial domain such as lightweight structure design, impact energy absorption, acoustical wave attenuation, etc. The behaviour of these foams at high strain rates is therefore desired. However, the rate sensitivities of these foams are not well caracterisized because of experimental difficulties. Actually, commonly used testing technique such as classical Split Hopkinson Pressure Bar (SHPB) does not provide satisfactory results. If a classical SHPB system composed of small diameter steel bars (about 10mm) is used, an important impedance difference between bars and foam specimen or a small specimen size with respect to the cell size will result in a poor measuring accuracy. This paper presents a new testing device (a 60mm diameter nylon Hopkinson bar system) which provides an interesting solution of these deficiency. A closed outer-surface aluminium foams cylindrical specimen (4.5mm diameter and 60mm length) were tested in both common SHPB and block bar configuration. With the quasi-static tests, three groups of testing results are given for following loading speeds: 1 mm/min, 10m/s, 27m/s. Even though there are unavoidable scatters for this kind,of materials, the rate sensitivity is clearly observed. In addition, tests with rate jump on the same specimen (static loading after dynamic one or dynamic after static one) have been performed. It shows a discontinuity of stress-strain curve. This gives another proof that the material is rate sensitive in this range of loading rate.

Test of Aluminum Foam Deforming Process under Impact Load Based on Digital Image Correlation Method

Deformation and stress nonuniformity of aluminum foam under different impact speeds

The Deformation Measurement and Analysis on Meso-Structure of Aluminum Foams During Shpb Test

Meso deformation characteristics analysis ofaluminum foam under impact

Localized deformation in aluminium foam during middle speed Hopkinson bar impact tests

Features of Meso-Deformation and Failure of Aluminum Foam under Impact

Tracking and Analysis of Aluminum Foam Deformations in SHPB Experiment by Using High-speed Camera

Experimental investigation on the strain-rate effect and inertia effect of closed-cell aluminum foam subjected to dynamic loading

Measurement of Dynamic Compressive Behavior of Aluminum-alloy Foams by Polycarbonate SHPB System

Investigation into Deformation Characteristics of Aluminum Foam Using Digital-Image Processing Technology

Deformation Process Study of Aluminum Foam at High Dynamic Temperature Based on SHPB

Temperature Effects on the Mechanical Behavior of Aluminum Foam under Dynamic Loading

Experimental Study of Aluminium Foams under Impact Loading

Parameter Study on Material Model of Aluminium Foams under Impact Load

Impact Testing of Polymeric Foam Using Hopkinson Bars and Digital Image Analysis

Dynamic Impact Behavior of Aluminum Foam with a Taylor Impact Test and a Theoretical Analysis

Damage Analysis of Aluminium Foam Panel Subjected to Underwater Shock Loading

Experimental and mesoscopic investigation of double-layer aluminum foam under impact loading

Deformation behavior and mechanical properties of aluminium foam sandwiches under static three-point bending

Digital Speckle Correlation Method and Its Application on Impact Deformation Measurement

Numerical Study of Dynamic Compression Process of Aluminum Foam with Material Point Method