Abstract:This work focuses on the combination of two complementary non-destructive techniques to analyse the final deformation and internal damage induced in aramid composite plates subjected to ballistic impact. The first analysis device, a 3D scanner, allows digitalising the surface of the tested specimen. Comparing with the initial geometry, the permanent residual deformation (PBFD) can be obtained according to the impact characteristics. This is a significant parameter in armours and shielding design. The second inspection technique is based on computed tomography (CT). It allows analysing the internal state of the impacted sample, being able to detect possible delamination and fibre failure through the specimen thickness. The proposed methodology has been validated with two projectile geometries at different impact velocities, being the reaction force history on the specimen determined with piezoelectric sensors. Different loading states and induced damages were observed according to the projectile type and impact velocity. In order to validate the use of the 3D scanner, a correlation between impact velocity and damage induced in terms of permanent back face deformation has been realised for both projectiles studied. In addition, a comparison of the results obtained through this measurement method and those obtained in similar works, has been performed in the same range of impact energy. The results showed that CT is needed to analyse the internal damage of the aramid sample; however, this is a highly expensive and time-consuming method. The use of 3D scanner and piezoelectric sensors is perfectly complementary with CT and could be relevant to develop numerical models or design armours.

Dynamic penetration of cellular solids: Experimental investigation using Hopkinson bar and computed tomography

Dynamic impact testing of cellular solids and lattice structures: Application of two-sided direct impact Hopkinson bar

Flash X-ray radiography of internal damage in soft cellular materials during instrumented dynamic penetration

Experimental investigation on the strain-rate effect and inertia effect of closed-cell aluminum foam subjected to dynamic loading

Experimental and Numerical Study of Ballistic Resistance of Composites Based on Sandwich Metallic Foams

Performance of Hollow and Aluminum Foam-Filled Multi-Cell Thin-Walled Aluminum Alloy Tubes (6063-T5) under Axial Impact

Postmortem Analysis Using Different Sensors and Technologies on Aramid Composites Samples after Ballistic Impact

Experimental and Numerical Analysis of Aluminum-Polyethylene Composite Structure Subjected to Tension and Perforation Under Dynamic Loading for a Wide Range of Temperatures

Assessment of Multilayered Plates with Hyperelastic Coatings Subjected to Dynamic Loadings by Impact at Low Velocities

Energy Absorption and Impact Resistance of Sandwich Composite Alloy Structures under Dynamic Impact

Dynamic enhancement mechanism of energy absorption of multi-cell thin-walled tube

Failure Investigations on Low Velocity Ballistic Impact Deformation of Closed-Cell Aluminum Metal Foam Targets

Research on Several Problems in the Characterization of Lightweight Cellular Materials by Low-Impedance Hopkinson Pressure Bar

Analysis of the meso‐mechanical deformation behavior of Al foams and Ni/Al hybrid foams using time‐lapse μCT measurements and 3D Optical Flow

Experimental and mesoscopic investigation of double-layer aluminum foam under impact loading

Energy Absorption Behaviour of Metallic Cellular Materials Under Impact Loading

Effect of Filler on the Mechanical and Dynamic Properties of Impact Energy-Absorbing Materials

Ballistic performance of Polycarbonate and Polymethyl methacrylate under normal and inclined dynamic impacts

Energy Absorption of Aluminum Panels Subjected to Gelatin Projectile Impact

Numerical Investigation on Dynamical Response of Aluminum Foam Subject to Hypervelocity Impact with Material Point Method

Test of Aluminum Foam Deforming Process under Impact Load Based on Digital Image Correlation Method