Abstract:Experiments have been carried out to study the effects of macroscopic open-pores on the damping behavior of foamed commercially pure aluminum(FA).The damping characterization was conducted on a multifunction internal friction apparatus(MFIFA).The FA specimens were prepared by air pressure infiltration process.The size of macroscopic pores is on the order of a millimeter(0.8 and 1.4 mm) and in large proportions,typically up to 76 vol.%.The internal friction(IF) of the FA specimen was measured at different temperatures,different frequencies,and different amplitude dependences.The measured IF shows that FA has a damping capacity which is enhanced in comparison with bulk commercially pure aluminum,increases with increasing porosity,increases with decreasing macropore size,increases with increasing frequency and increases with increasing strain amplitude.The microstructural analysis was performed using transmission electron microscopy(TEM).TEM observations show that moderate density of dislocation substructures exist near the grain boundaries in the FA.In light of IF measurements and microstructural observations,the possible operative damping mechanisms in the FA are the stress concentration and mode conversion around macroscopic pores,the elastic modulus difference between the matrix and the macroscopic pores that results in a marked inhomogeneous stress,inhomogeneous expansion deformation around macroscopic pores.

Local deformation on damping performance of integral-forming aluminum foam sandwich

Compression performances of integral-forming aluminum foam sandwich

Mechanical Simulation of the Localized Deformation in the Aluminum Foams: A Three-Dimensional (3d) Structure Based Study

Three-point bending performances of integral-forming aluminum foam sandwich

Dynamic and Static Compression Tests and FEA Analyses of Aluminum Foam Specimen with Variable Density in the Loading Direction

Study on Damping Behavior of Foamed Aluminum with Macroscopic Pores

Numerical Study of Dynamic Compression Process of Aluminum Foam with Material Point Method

Low-Velocity Impact Response of Fully Clamped Metal Foam Core Sandwich Beam Incorporating Local Denting Effect

Experimental investigation on the strain-rate effect and inertia effect of closed-cell aluminum foam subjected to dynamic loading

Fabrication and Interfacial Characterization of Aluminum Foam Sandwich Via Fluxless Soldering with Surface Abrasion

Analytical solution for pin-supported metal foam core sandwich beam with local denting

Aluminum Foam Sandwich: Pore Evolution Mechanism Investigation and Engineering Preparing Optimization

Modeling of Macro-Deformation Behavior of Thin-Walled Aluminum Foam by Gas Injection Method

Dynamic response and energy absorption of aluminum foam sandwich under low-velocity impact

A RATE-DEPENDENT CONSTITUTIVE MODEL FOR ALUMINUM FOAMS AND ITS APPLICATION TO THE ENERGY ABSORPTION OF LIGHTWEIGHT SANDWICH PANELS WITH ALUMINUM FOAM CORES

A Double Degree Freedom Mass-Spring-Damper-Foam Collision Model for High Porosity Metallic Foams

Construction and deformation behavior of metal foam based on a 3D-Voronoi model with real pore structure

Nonlinear Internal Friction Character of Foamed Aluminum

Localized Indentation of Sandwich Panels with Metallic Foam Core: Analytical Models for Two Types of Indenters

Plastic analysis of metal foam core sandwich beam transversely loaded by a flat punch: Combined local denting and overall deformation

Dynamic Deformability of Cell in Aluminum Foams