Abstract:A numerical model of the aluminium foam with voronoi cells is built and crushed with various velocities from 1m/s to 110m/s. It is shown that the foam deforms homogeneously within the whole specimen and the stress in the foam increases gradually with the strain without an obvious plateau stage under the low-velocity compression, while the deformation is concentrated within a zone near the impact end and an obvious plateau stage can be found in the stress-strain curves of the foams under the high-velocity crushing. The distribution of the density within the crushed foam is measured by the digital image processing. Accordingly, the distribution of the stress can be obtained based on the plastic constitution obtained from the experiments. It is shown that under the high-velocity crushing, the stress within the deformed zone decrease rapidly from the maximum lying at the impact end to the undeformed zone, and the higher the impact velocity is, the more nonuniformly the stress distributes. By measuring the average density of the deformed zone of the foam, the densification strain of the foams under dynamic crushing can be determined. Then combining the foam`s stress-strain curve under the low-velocity compression, the dynamic plateau stress of the foams can be predicted. It is shown that both the densification strain and the foams' dynamic plateau stress predicted by employing the digital image process technology are in good agreement with the numerical simulations. The results show that both the plateau stress and the densification strain of the foams increase with the impact velocity, which is essentially caused by the localization of the foam`s deformation under dynamic crushing.

Numerical Study of Dynamic Compression Process of Aluminum Foam with Material Point Method

Numerical Investigation on Dynamical Response of Aluminum Foam Subject to Hypervelocity Impact with Material Point Method

Parameter Study on Material Model of Aluminium Foams under Impact Load

Dynamic Impact Behavior of Aluminum Foam with a Taylor Impact Test and a Theoretical Analysis

Numerical Study of Dynamic Behavior of Foams Subjected to High- to Hyper-Velocity Impact

Dynamic and Static Compression Tests and FEA Analyses of Aluminum Foam Specimen with Variable Density in the Loading Direction

Numerical Simulation of Blast-resistant Performance of Aluminum Foam Sandwich Structures and Optimization

Three-dimensional Voronoi-based simulation study of stepwise density-graded aluminum foams: Buffering and energy absorption performance analysis

Numerical Simulation Investigation in Behavior of Al-Foams Structure under Hypervelocity Impact

Experimental and Numerical Analyses on the Dynamic Response of Aluminum Foam Core Sandwich Panels Subjected to Localized Air Blast Loading

A RATE-DEPENDENT CONSTITUTIVE MODEL FOR ALUMINUM FOAMS AND ITS APPLICATION TO THE ENERGY ABSORPTION OF LIGHTWEIGHT SANDWICH PANELS WITH ALUMINUM FOAM CORES

A Numerical Study of Temperature Effect on the Penetration of Aluminum Foam Sandwich Panels under Impact

Numerical Simulation of Explosively Driven Metal by Material Point Method

Numerical Simulation on Dynamic Indentation Behavior of Sandwich Plates with Aluminum Foam Cores

Measurement of Dynamic Compressive Behavior of Aluminum-alloy Foams by Polycarbonate SHPB System

Dynamic Mechanical Behaviors of Aluminium Foam Filled Circular Tubes under Transverse Compressive Load

Numerical simulation of dynamic response of functionally graded aluminum foam sandwich panels under air blast loading

Dynamic Behaviors Of Aluminum Foam Based On The New Empirical Constitution

Features of Meso-Deformation and Failure of Aluminum Foam under Impact

Experimental investigation on the strain-rate effect and inertia effect of closed-cell aluminum foam subjected to dynamic loading

A Constitutive Model of Aluminum Foam for Crash Simulations