Abstract:A numerical model of the aluminium foam with voronoi cells is built and crushed with various velocities from 1m/s to 110m/s. It is shown that the foam deforms homogeneously within the whole specimen and the stress in the foam increases gradually with the strain without an obvious plateau stage under the low-velocity compression, while the deformation is concentrated within a zone near the impact end and an obvious plateau stage can be found in the stress-strain curves of the foams under the high-velocity crushing. The distribution of the density within the crushed foam is measured by the digital image processing. Accordingly, the distribution of the stress can be obtained based on the plastic constitution obtained from the experiments. It is shown that under the high-velocity crushing, the stress within the deformed zone decrease rapidly from the maximum lying at the impact end to the undeformed zone, and the higher the impact velocity is, the more nonuniformly the stress distributes. By measuring the average density of the deformed zone of the foam, the densification strain of the foams under dynamic crushing can be determined. Then combining the foam`s stress-strain curve under the low-velocity compression, the dynamic plateau stress of the foams can be predicted. It is shown that both the densification strain and the foams' dynamic plateau stress predicted by employing the digital image process technology are in good agreement with the numerical simulations. The results show that both the plateau stress and the densification strain of the foams increase with the impact velocity, which is essentially caused by the localization of the foam`s deformation under dynamic crushing.

Deformation and stress nonuniformity of aluminum foam under different impact speeds

Test of Aluminum Foam Deforming Process under Impact Load Based on Digital Image Correlation Method

Features of Meso-Deformation and Failure of Aluminum Foam under Impact

Meso deformation characteristics analysis ofaluminum foam under impact

The Deformation Measurement and Analysis on Meso-Structure of Aluminum Foams During Shpb Test

Experimental investigation on the strain-rate effect and inertia effect of closed-cell aluminum foam subjected to dynamic loading

Localized deformation in aluminium foam during middle speed Hopkinson bar impact tests

Temperature Effects on the Mechanical Behavior of Aluminum Foam under Dynamic Loading

Measurement of Dynamic Compressive Behavior of Aluminum-alloy Foams by Polycarbonate SHPB System

Tracking and Analysis of Aluminum Foam Deformations in SHPB Experiment by Using High-speed Camera

Experimental Study of Aluminium Foams under Impact Loading

Deformation Process Study of Aluminum Foam at High Dynamic Temperature Based on SHPB

Investigation into Deformation Characteristics of Aluminum Foam Using Digital-Image Processing Technology

Parameter Study on Material Model of Aluminium Foams under Impact Load

Dynamic Behaviors Of Aluminum Foam Based On The New Empirical Constitution

Deformation Characteristic of Metal Foam under Different Strain Rate and Temperature

Mechanical Properties and Constitutive Model Applied to the High-Speed Impact of Aluminum Foam That Considers Its Meso-Structural Parameters.

Numerical Analysis on Usability of SHPB to Characterize Dynamic Stress–Strain Relation of Metal Foam

Compressive Behavior and Deformation Mechanism of Aluminum Foam under Different Temperature

Shock Enhancement of Aluminum Foam under Impact Loading Using Fem Simulations

Dynamic mechanical properties of aluminum alloy foams