Leakage current mechanism and effect of Y 2 O 3 doped with Zr high-K gate dielectrics

k c lin,p c juan,c h liu,m c wang,c h chou
DOI: https://doi.org/10.1016/j.microrel.2015.07.045
IF: 1.6
2015-01-01
Microelectronics Reliability
Abstract:In this study, a Y2O3 film doped with Zr was fabricated to form two stacked structures, Al/ZrN/Y2O3+Zr/Y2O3/p-Si (with Zr in the upper layer) and Al/ZrN/Y2O3/Y2O3+Zr/p-Si (with Zr in the lower layer), at rapid thermal annealing (RTA) temperature range of 550, 700, and 850°C. To analyze the leakage current mechanism, leakage current versus voltage (I–V) and capacitance versus voltage (C–V) characteristics of these two structures were first investigated. By analyzing Schottky emission (SE) and the fit of its equation with experimental data and parameters, dielectric constants were computed to be 11.3 and 6.34, equivalent oxide thicknesses (EOTs) were determined to be 2.42 and 4.3nm, Schottky barrier heights were calculated to be 0.81 and 0.82eV, and dynamic dielectric constants were determined to be 13 and 8 for structures with Zr in the upper and lower layers, respectively. By analyzing Poole–Frenkel (P–F) emission and the fit of its equation with experimental data and parameters, trap energy levels were computed to be 0.45 and 0.5eV, and dynamic dielectric constants were determined to be 1.65 and 2.61 for structures with Zr in the upper and lower layers, respectively. The characteristics of ln(J/T2) versus E0.5 and ln(J/T2) versus 1000T in SE and P–F emission were linear, thus conforming to the theoretical equations. Finally, the results of computed parameters in the two structures were compared to validate the leakage current mechanism.
What problem does this paper attempt to address?