Abstract:ASTRACT Electrodeposition of conformal and compact SnO 2 films on transparent conductive oxides (TCOs) has been hardly achieved thus limiting its application in fully solid solar cells such as those based in perovskite absorbers. Here are presented high-quality n-type semiconducting tin (VI) oxide (SnO 2 ) thin films, successfully grown using a hybrid potentiodynamic/potentiostatic approach on both ITO and FTO coated glass substrates after a detailed optimization that included both annealing steps between eletrodepositions. A solution chemistry study together with a spectrophotometric analysis was useful to determine the one-hour time window of stability for the chosen electrolyte as source of tin. Formation mechanisms based in thermodynamic data and accumulated mass measurements using an electrochemical quartz crystal microbalance (EQCM) are discussed. From the EQCM study the growth rate of films was also estimated in good agreement with high resolution transmission electron microscopy (HR-TEM) analysis. Field emission scanning electron microscopy (FE-SEM) images and X-ray diffraction (XRD) data revealed that substrates are well-covered, crystalline, conformal and free of defects ( e.g . without pinholes). The absence of these defects was also well supported by cyclic voltammetry measurements using the ferricyanide/ferrocyanide redox couple. XPS also confirmed the presence of Sn 4+ in optimized films. From the optical properties, after carefully eliminating the influence of oscillations due to interference, a direct bandgap energy at 3.60 eV can be deduced. Another indirect bandgap energy at 3.30 eV can also be possible. The hybrid potentiodynamic/potentiostatic protocol to prepare SnO 2 paves a way to prepare compact, transparent and well covering films suitable as electron transporting layer (ETL) for applications in both photoelectrochemical and solid-state solar cells.

Electrodeposition of Sno2 Thin Films from Aqueous Tin Sulfate Solutions

P-type Tin–indium Oxide Films Prepared by Thermal Oxidation of Metallic InSn Alloy Films

P-type Transparent Conducting Indium-Tin Oxide Thin Films Deposited by Spray-pyrolysis

Hybrid potentiodynamic/potentiostatic electrodeposition of thin and compact tin dioxide on indium tin oxide electrodes

A hexane solution deposition of SnS2 films from tetrabutyltin via a solvothermal route at moderate temperature

OPTICAL AND ELECTRICAL PROPERTIES OF SnO2:Sb THIN FILMS DEPOSITED BY SOL-GEL PROCESS

Optical and photoelectrocatalytic performance of Tin (II) oxide silicate (Sn 6 SiO 8 ) thin films as a photoanode by Aerosol Assisted Chemical Vapor Deposition

Electrodeposition of tin oxide thin film from nitric acid solution: the role of pH

Electrodeposition of Tin Selenide from Oxalate-Based Aqueous Solution

Fabrication of Highly Porous and Micropatterned SnO2 Films by Oxygen Bubbles Generated on the Anode Electrode

Preparation of Tin-Based Oxides Thin Films and Its' Electrochemical Properties

Tin‐Based Composite Oxide Thin‐Film Electrodes Prepared by Pulsed Laser Deposition

A novel synthesis of tin oxide thin films by the sol-gel process for optoelectronic applications

Low-Temperature One-Pot Synthesis of Tin(II) Sulfide Nanocrystalline Thin Films

Preparation and electrochemical properties of nanosized tin dioxide electrode material by sol-gel process

Facile Synthesis and Characterization of TiO2/SnS Nanocomposites by Eco-Friendly Methods

Influence of deposition potential and substrate characteristics on the photovoltaic conversion efficiency of p-SnS absorbing layers

Enhanced Thermoelectric Performance of Tin(II) Sulfide Thin Films Prepared by Aerosol Assisted Chemical Vapor Deposition

Electrochemistry of Tin Deposition from Methanesulfonic Acid

Electrochemically synthesized tin selenide thin films as efficient electrocatalyst for overall water splitting

Hydrothermal Preparation and Characterization of Nanocrystalline Porous Tin Dioxide Thin Films