Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Mechanical Expansion of Thick-Walled Microgroove Tube for High Pressure Acr System

Influence of mechanical properties of tube on forming limits and deformation characteristics in expansion drawing process

A Theoretical Study of the Expansion Metal Tubes

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Joining by forming technology for thermal applications: A case study of finned tube heat exchanger

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Hydraulic Expansion Joint Contact State of Heat Exchanger Based on New Contact Area Measurement Method

Influence of Process Parameters on Thinning Ratio and Fittability of Bellows Hydroforming

Experimental Study on Double-layered Tube During Hydraulic Expansion

An Improved Two-Arcs Deformational Theoretical Model of the Expansion Tubes

Experimental and numerical study of the flaring process for Zircaloy tube end

Theoretical Analysis and Numerical Simulation on the Hydraulic Expansion of Double-Layered Tubes

Combined Effect of Tungsten Inert Gas Welding and Roller Expansion Processes on Mechanical and Metallurgical Characteristics of Heat Exchanger Tube-To-Tubesheet Joints

Forming mechanism of double-layered tubes by internal hydraulic expansion

Influence of process parameters on the flow forming quality of thin-walled tube with large diameter-thickness ratio

Enhanced refrigerant flow boiling heat transfer in microstructured finned surfaces

Solid expandable tubular forming behavior based on twin shear stress yield criterion: Analytical, numerical simulation and experiment

Analytical prediction of stress and strain in adhesive tube-to-tube joints under thermal expansion/contraction

Plastically Deformed Tubes Subjected to Mechanical Expansion Processes

Complex Turbulent Flow and Heat Transfer Characteristics of Tubes with Internal Longitudinal Plate-Rectangle Fins in EGR Cooler

Study on forming process of equal wall thickness metal spiral pipe by single screw pump