Abstract:CaCu 3 Ti 4 O 12 (CCTO) nanomaterials were synthesized using the low-cost facile sol-gel technique. X-ray diffraction (XRD) patterns confirmed the cubic structure of the prepared sample. Scherrer's formula and the W-H (Williamson-Hall) plot was used to calculated the average crystallite size of the prepared sample and it was found to be 27 nm and 31.3 nm, respectively, while the strain created in the lattice is 5.008 × 10 −4 . Based on the absorbance plot, the band-gap ( E g ) of the sample was determined using Tauc's plot and it was found out to be 2.74 eV. The frequency dependence of dielectric permittivity ( ε ) and tangent loss ( tan δ ) of CCTO was analyzed at different temperature range from 300 K to 663 K over a frequency range from 10 Hz to 1 MHz. ε and tan δ decrease monotonically in entire frequency range and an anomalous frequency-dependent behavior was observed at different temperatures. High ε (in the range of 10 4 ) was found out at lower frequency range. Electrical conductivity was also analyzed in range of frequencies and temperature, it was found out that in higher region of frequency conductivity slightly increases. The room temperature values of ε , tanδ and conductivity was 7.5 × 10 3 , 1.5 and 0.4 × 10 −5 Ω −1 m −1 , respectively. The reduction in E g is achieved which was the major concern in this work. Furthermore, we have extensively studied the ε along with tan δ and ac conductivity for electronic application usage. According to these observations, CCTO is particularly prepared so that it could be suitable for microelectronic applications due to its high ε and low tan δ .

High Dielectric Permittivity and Low Dielectric Loss in Sol–gel Derived Zn Doped CaCu3Ti4O12 Thin Films

Microstructure, surface morphology and optical properties of Na x Cu y Zn 1− x − y O thin films

Effect of Cu Concentration on Optical Properties of Zn1-xCuxO Thin Films

Influence of zinc on electrical and microstructural properties of CaCu3Ti4O12 ceramics prepared by sol–gel process

Microstructue and Optical Properties of Mg-doped ZnO Thin Films Prepared by Sol-gel Method

Influence of zinc on electrical and microstructural properties of CaCu 3Ti 4O 12 ceramics prepared by sol-gel process

Dielectric Properties of Zr-Doped CCTO Based Ceramics Prepared via Sol-Gel Method

Effects of Zr Doping on the Microstructures and Dielectric Properties of CaCu3Ti4O12 Ceramics

Tuning Electrical Heterogeneity in CaCu3Ti4O12-ZnO Ceramics for High Dielectric and Nonlinear Properties

Preparation and characterization of Mg-doped CaCu3Ti4O12 thin films

Effects of Mn doping on structural and dielectric properties of sol-gel-derived (Ba 0.835Ca 0.165)(Zr 0.09Ti 0.91)O 3 thin films

Polarization Fatigue Resistance of Ca-doped Pb(Zr0.52Ti0.48)O3 Thin Films Prepared by the Sol–gel Method

Microstructure and electrical properties of sol–gel derived Ni-doped CaCu3Ti4O12 ceramics

Preparation, Structure and Dielectric Properties of Catio3:Zn Ceramics Based on Sol-Gel Technology

Doping and Annealing Effects on ZnO:Cd Thin Films by Sol–gel Method

Dielectric properties and optical propagation loss of c-axis oriented ZnO thin films deposited by sol-gel process

Enhanced Electrical Properties of CaCu3Ti4O12 Ceramics by Spark Plasma Sintering: Role of Zn and Al Co-Doping

Improved Dielectric, Nonlinear and Magnetic Properties of Cobalt-Doped CaCu3Ti4O12 Ceramics

Strontium doped CaCu3Ti4O12 ceramics with very low dielectric loss synthesized by the sol–gel method

Microstructure and dielectric properties of Nd doped CaCu 3 Ti 4 O 12 synthesized by sol–gel method

Structural and dielectric properties of CaCu3Ti4O12 synthesized by sol–gel method