Abstract:Process and supply variations all have a large influence on current-mode signaling (CMS) circuits, limiting their application on the fields of high-speed low power communication over long on-chip interconnects. A variation-insensitive CMS scheme (CMS-Bias) was offered, employing a particular bias circuit to compensate the effects of variations, and was robust enough against inter-die and intra-die variations. In this paper, we studied in detail the principle of variation tolerance of the CMS circuit and proposed a more suitable bias circuit for it. The CMS-Bias with the proposed bias circuit (CMS-Proposed) can acquire the same variation tolerance but consume less energy, compared with CMS-Bias with the original bias circuit (CMS-Original). Both the CMS schemes were fabricated in 180 nm CMOS technology. Simulation and measured results indicate that the two CMS interconnect circuits have the similar signal propagation delay when driving signal over a 10 mm line, but the CMS-Proposed offers about 9% reduction in energy/bit and 7.2% reduction in energy-delay-product (EDP) over the CMS-Original. Simulation results show that the two CMS schemes only change about 5% in delay when suffering intra-die variations, and have the same robustness against inter-die variations. Both simulation and measurements all show that the proposed bias circuits, employing self-biasing structure, contribute to robustness against supply variations to some extent. Jitter analysis presents the two CMS schemes have the same noise performance.

Process Variation Robust Current-Mode On-Chip Interconnect Signaling Scheme

A Low Power And Variation-Insensitive Current-Mode Signaling Scheme

Robust Current-Mode On-Chip Interconnect Signaling Scheme in Deep Submicron

New Technique: A Low Drift Current Reference Based on PMOS Temperature Correction Technology.

A method to reduce process-related sensitivity in sub-threshold ICs and its circuit implementation

Variation-aware gate sizing and clustering for post-silicon optimized circuits.

Bandgap Voltage Reference Design with Enhanced Tolerance of Process Variations

Design Time Body Bias Selection for Parametric Yield Improvement.

The optimization design method of low power current-mode interconnect circuit based fast approach

Bias Current Compensation Method with 41.4% Standard Deviation Reduction to MOSFET Transconductance in CMOS Circuits

A Novel Adaptive Reverse Body Bias Technique to Minimize Standby Leakage Power and Compensate Process and Temperature Variations

Dynamic Current Balancing for Paralleled SiC MOSFETs with Circuit Mismatches Considering Circulating C Urrent in Drive Circuit

Output Curves Based Hierarchical Clustering Screening Method with Static/Dynamic Current Balancing for Paralleled SiC MOSFETs

On-Chip Process Variation Sensor Based on Sub-Threshold Leakage Current with Weak Bias Voltages

A Tdc Based Process Variation Sensor for Both Nmos and Pmos Variation Monitoration

A Combined Model Predictive Current Control for SPMSM Drive with Improved Robustness and Control Precision

A Method to Balance Dynamic Current of Paralleled SiC MOSFETs With Kelvin Connection Based on Response Surface Model and Nonlinear Optimization

Surviving Process Variation: Investigation of Cnr Mosfets with Tapered Channels Using Fully Self-Consistent Negf and Tight-Binding Methods

A novel approach to estimate the impact of analog circuit performance based on the small signal model under process variations

A Statistical Characterization of CMOS Process Fluctuations in Subthreshold Current Mirrors

All CMOS Temperature, Supply Voltage and Process Independent Current Reference