Abstract:In this paper, a low power transceiver for wireless sensor networks (WSN) is proposed. The system is designed with fully functional blocks including a receiver, a fractional-N frequency synthesizer, and a class-E transmitter, and it is optimized with a good balance among output power, sensitivity, power consumption, and silicon area. A transmitter and receiver (TX-RX) shared input-output matching network is used so that only one off-chip inductor is needed in the system. The power and area efficiency-oriented, fully-integrated frequency synthesizer is able to provide programmable output frequencies in the 2.4 GHz range while occupying a small silicon area. Implemented in a standard 0.18 μm RF Complementary Metal Oxide Semiconductor (CMOS) technology, the whole transceiver occupies a chip area of 0.5 mm2 (1.2 mm2 including bonding pads for a QFN package). Measurement results suggest that the design is able to work at amplitude shift keying (ASK)/on-off-keying (OOK) and FSK modes with up to 500 kbps data rate. With an input sensitivity of −60 dBm and an output power of 3 dBm, the receiver, transmitter and frequency synthesizer consumes 2.3 mW, 4.8 mW, and 3.9 mW from a 1.8 V supply voltage, respectively.

A Low Voltage Low Power Up-Conversion Mixer for WSN Application

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A 11 Mw 2.4 GHz 0.18 Μm CMOS Transceivers for Wireless Sensor Networks

A group-selected and gain controllable CMOS active mixer for UWB applications

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

A LOW POWER, HIGH-LINEARITY CMOS DOWNCONVERSION FOLDED MIXER FOR 2.4GHz ISM BAND APPLICATIONS

A 5 GHz low power 0.18μm CMOS Gilbert cell mixer

Design and Analysis of an Ultrawide-Band Distributed Drain-Pumped Mixer Using 0.18µm CMOS Technology

Low Voltage, Low Power, Downconversion Folded-Switching Mixer With Current-Reuse Technology

A 0.1-1.9Ghz 65nm CMOS Variable-Gain Mixer-First Receiver with DSA and Noise-Shaping TIA.

An Ultra-Low Power K band Balanced Frequency Doubler with a Novel Current-reused Structure

A New Low Voltage RF CMOS Mixer Design

Low Voltage CMOS Gilbert Mixers for Bluetooth Transceiver

CMOS Mixers for 2.4GHz WLAN Transceivers

A Low-Power 2.4-Ghz Receiver Front-End with a Complementary Series Feedback LNA and a Current-Reused Passive Down-Converter Based on Gm-Boosted TIA for WSN Applications.

A CMOS down-conversion micromixer for IEEE 802.11b WLAN transceivers

A 900mhz High Linearity Low Power Down-Conversion Mixer

2.4 GHz 0.35μm CMOS gilbert down-conversion mixer

Low power, high linearity multi-mode downconversion mixer for SDR

Analysis and Design of a Low-Voltage RF CMOS Mixer

A 24‐ghz Active Up/down Bidirectional Mixer in 130‐nm RF CMOS