Abstract:The compressive response of a NiTi shape-memory alloy is investigated at high strain rates, using UCSD’s modified split Hopkinson pressure bar and a mini-Hopkinson bar with specially designed striker bars. To obtain a constant strain rate during the formation of the stress-induced martensite phase in a Hopkinson test, a copper-tube pulse shaper of suitable dimensions or a stepped striker bar is employed, since without a pulse shaper or with a uniform striker bar, the strain rate of the sample will vary significantly as the material’s microstructure changes from austenite to martensite, whereas with proper pulse shaping techniques a nearly constant strain rate can be achieved over a certain deformation range. At a very high strain rate, the yield stress and the stress-induced martensite formation process are significantly different from those at moderately high strain rates, suggesting that, correspondingly, different microstructural changes may be involved in the phase transition regime. The material’s yield stress appears lower when measured in a mini-Hopkinson bar (with very small samples) as compared with that measured by a 1/2-in. Hopkinson bar (with relatively large samples), possibly due to the sample size that may produce different deformation mechanisms within the superelastic strain range. The transition stress from the austenite to the martensite phase shows strain-rate sensitivity. This may be explained by considering the interfacial motion of the formed martensite phase, based on the thermally activated and dislocation-drag models. There exists a certain critical strain-rate level, at which the transition stress for the stress-induced martensite formation equals the yield stress of the austenite phase. Therefore, the shape-memory alloy deforms by the formation of stress-induced martensites, accompanied by the yielding of the martensite phase at this critical strain rate, while the material deforms plastically by the dislocation-induced plastic slip at strain rates above this critical level.

High-Strain-Rate Response of a Specially-Made Copper Sample

The Meso-inhomogeneous Deformation of Pure Copper under Tension–Compression Cyclic Strain Loading

Experimental Investigation on Strain Rate Sensitivity of Ultra-Fine Grained Copper at Elevated Temperatures

Dynamic tests and constitutive model for 7075-T6 aluminum alloy

The mechanical response of commercially pure copper under multiaxial loading at low and high strain rates

A Dynamic Mechanical Analysis of T2 Copper at High Strain Rates

Very High Strain-Rate Response of a NiTi Shape-Memory Alloy

Effect of High Temperature and High Strain Rate Coupling on the Property of Single-crystal Nickel-base Superalloy DD407

Thermo-viscoplastic Behavior and Constitutive Modeling of Pure Copper under High-Strain-rate Shear Condition

Compressive Behavior and Rate-Controlling Mechanisms of Ultrafine Grained Copper over Wide Temperature and Strain Rate Ranges

Constitutive Modelling of Plasticity of Fcc Metals under Extremely High Strain Rates

Plastic Behavior and Constitutive Relations of DH-36 Steel over a Wide Spectrum of Strain Rates and Temperatures under Tension

Microstructures and mechanical properties of Cu-Sn alloy subjected to elevated-temperature heat deformation

High-entropy CoCrFeMnNi Alloy Subjected to High-Strain-rate Compressive Deformation

Plastic Deformation Behavior and Constitutive Modeling of Cu-50Ta Alloy During Hot Compression

Compressive Rheological Behavior and Microstructure Evolution of a Semi-Solid CuSn10P1 Alloy at Medium Temperature and Low Strain

Tensile Ductility of Ultra-Fine Grained Copper at High Strain Rate

Experimental Study of Mechanical Properties at High Strain Rate and Constitutive Relation of Aluminum Alloy 2A70

Temperature And Strain Rate Sensitivity Of Ultrafine-Grained Copper Under Uniaxial Compression

Temperature And Strain Rate Effects On The Strength And Ductility Of Nanostructured Copper

High Strain Rate Deformation Behavior of 2195 Al-Li Alloy: Constitutive Behavior and Grain Fragmentation