Abstract:There are heat transfer correlations for heat transfer analysis in single tube geometries after several experimental and theoretical heat transfer studies in these single tube geometries. This is not the case for heat transfer analysis in rod bundle geometry with regard to proposed square fuel assembly of the Supercritical-Water-Cooled Reactor (SCWR) European Atomic Energy (EURATOM) design. Thus limited heat transfer studies exist on rod bundle geometry at supercritical pressures. Heat transfer correlations with accurate prediction capabilities of coolant and wall temperatures will be helpful in carrying out heat transfer studies at supercritical pressures. This paper presents the performance of twelve selected heat transfer correlations assessed on the 1/8th bare square fuel assembly of the SCWR EURATOM design using Simulation of Turbulent flow in Arbitrary Regions Computational Continuum Mechanics C ++ based code (STAR-CCM + CFD code). The obtained numerical results were compared with the results obtained by Waata numerical experimentation. Overall, the Cheng et al. correlation provided the most satisfying prediction for the wall temperatures in all the sub-channels and captured closely Wataa's Numerical data. The maximum wall temperature was obtained in sub-channel 9, the hottest sub-channel and exceeded the design limit 620 °C by 60 °C for the Cheng correlation. The difference in temperature between the hottest and coldest sub-channels 9 and 1 respectively was approximately 80 °C. It was found that Cheng correlation is best suited for heat transfer prediction in rod bundle geometry at supercritical pressures with regard to the proposed square fuel assembly of the SCWR EURATOM design. It was also found that the different numerical tools adopted for this study and Waata study were able to capture the trends of normal, enhanced and deteriorated heat transfer regimes normally observed at supercritical pressures. Nevertheless, experimental investigations involving rod bundles adopted in this study should be conducted to validate the results obtained numerically and address the inconsistency of the conclusions drawn when compared with Waata data and other similar studies.

Uniform Versus Nonuniform Axial Power Distribution in Rod Bundle CHF Experiments

Prediction of Critical Heat Flux in Non-Uniform Heated Rod Bundle Based on Modified CHF Empirical Correlations

Assessment of a Theoretical Model for Predicting Forced Convective Critical Heat Flux in Rod Bundles

Research on prediction of non-uniform heated rod bundle CHF based on subchannel analysis code coupling modified mechanistic model

Subchannel Analysis of Critical Heat Flux in Radially Non-Uniform Heated Rod Assembly at Low Flow Rate

Investigation on the Critical Heat Flux in Typical 5 by 5 Rod Bundle at Conditions Prototypical of PWR Based on CFD Methodology

Fluid-to-fluid Modeling of Critical Heat Flux in 4×4 Rod Bundles

Mechanistic Model of Critical Heat Flux in Rod Bundles Based on a High-Precision Subchannel Code

Study on the Prediction of DNB-Type Critical Heat Flux in Rod Bundle Under Motion Conditions

Applicability Research of Round Tube CHF Mechanistic Model in Rod Bundle Channel

A Correlation Of Heat Transfer Non-Uniformity In Rod Bundle And Its Application To Sub-Channel Code

Investigation on Rod Bundle CHF Mechanistic Model for DNB and DO Prediction Under Wide Parameter Range

Nonuniform Heat Transfer of Supercritical Water in a Tight Rod Bundle – Assessment of Correlations

An experimental study of the CHF in a square channel with non-uniformly heated rod under low pressure and low flow conditions

An experimental study on critical heat flux for low flow and low pressure of water in a hexagonal 7-rod bundle channel

Prediction of Dryout-Type CHF for Rod Bundle in Natural Circulation Loop under Motion Condition

Assessment of heat transfer correlations in the sub-channels of proposed rod bundle geometry for supercritical water reactor

The Development and Assessment of a New CHF Correlation for PWR Fuel Assemblies

Review of the AFD-type CHF Mechanistic Model and Its Application to Rod Bundle

Researches in the Flow Modeling of Critical Heat Flux in Bundle

CFD Investigation of the Cold Wall Effect on CHF in a 5 × 5 Rod Bundle for PWRs