Abstract:Accurate prediction of the heat transfer performance in tight rod bundles is important for the design and safety analysis of supercritical water-cooled reactors (SCWRs). However, the error of the current correlations for predicting supercritical heat transfer coefficient in rod bundle and grid spacer is large under certain conditions. In the present paper, an experimental study of heat transfer to supercritical water in a three-rod bundle with spacer grids is carried out at Shanghai Jiao Tong University. The rod bundle is composed of three heated rods and three unheated rod-like fillers with an outer diameter of 15 mm and a pitch-to-diameter ratio of 1.2. Honeycomb grid spacers with a blockage ratio of 0.158 are equipped in the bundle. The system pressure is 23 MPa and the mass flux ranges from 800 to 1600 kg/(m(2).s). Moreover, the heat flux varies from 400 to 700 kW/m(2) and the fluid temperature is in the range of 285-382 degrees C. Wall-temperature gradients are observed along the circumference direction of heated rods. The wall temperature is higher in the gap area between heated rods and it is lower in the cold-wall area. When approaching the pseudo-critical point, the non-uniformity of the wall temperature is significantly reduced. Six existing correlations for fully-developed heat transfer at supercritical pressure are assessed against the experimental data, among which the Bishop correlation gives the best predictions. A new correlation is developed based on the experimental data and most of them are predicted within +/- 15% with a mean absolute deviation of 6.0% and a root-mean-square deviation of 7.3%. The enhancement ratios of heat transfer downstream of spacers are substantially under-predicted by the commonly used correlations. Based on the observation that the maximum enhancement ratio increases linearly with the Reynolds number in pseudo-liquid regions, a new correlation is proposed to predict the heat transfer augmentation downstream of spacers, correlating most of the data within +/- 20% with a mean absolute deviation of 6.2% and a root-mean-square deviation of 8.4%.

The numerical investigation of the thermal–hydraulic behavior in a 3 × 3 rod bundle with spacer grids

Numerical Study on the Thermohydraulics of Near-Critical Water in Rod Bundle with Spacer Grids

Numerical Investigation of Flow and Heat Transfer Characteristics of Subcooled Boiling in a Single Rod Channel With/without Spacer Grid

Numerically simulating the thermal–hydraulic characteristics within the fuel rod bundle using CFD methodology

Numerical investigation on mixing performance in rod bundle with spacer grid based on anisotropic turbulent mixing model

Numerical Investigation of Turbulent Mixed Convection Flow and Heat Transfer Characteristics of 2 × 2 Subchannels with Spacer Grids

Simulation of Thermal-Hydraulic Behavior in Tight Lattice Rod Bundle

Turbulent Convective Heat Transfer Behavior of Supercritical Water Flowing Upward in 2 × 2 Rod Bundle Channels with Various Spacers

Numerical Simulation and Analysis of Flow and Heat Transfer in a 5 × 5 Vertical Rod Bundle with Buoyancy Effects

Numerical simulation prediction of critical heat flux for 5 × 5 rod bundle with multiple grid spacers and different cladding materials

CFD evaluation of turbulence models for flow simulation of the fuel rod bundle with a spacer assembly

Experimental Investigation on Heat Transfer to Supercritical Water in a Three-Rod Bundle with Spacer Grids

Simulation of Turbulent Flow and Heat Transfer in Channels Between Rod Bundles

LES and URANS Study on Turbulent Flow Through 3 × 3 Rod Bundle with Spacer Grid and Mixing Vanes Using Spectral Element Method

Numerical Investigation of the Effect of Mixing Vanes on Subcooled Boiling in a 3 × 3 Rod Bundle Channel with Spacer Grid

Numerical Study on the Flow and Heat Transfer Characteristics of Sub-channel with Triangle Distribution Using Gird Spacer in SCWR

Numerical Study on Flow and Heat Transfer Characteristics in the Rod Bundle Channels under Super Critical Pressure Condition

Investigating flow and heat transfer characteristics in a fuel bundle with split-vane pair grids by CFD methodology

The Effects of Spacer Grid Arrangement on Flow Boiling Characteristics and Critical Heat Flux in a Complex 5 × 5 Rod Bundle Channel

Numerical Investigation of Thermal-Hydraulic Behaviors in a LBE-cooled 19-Pin Wire-Wrapped Rod Bundle

Cfd Investigating the Effects of Different Mixing Vane Designs on the Localized Thermal-Hydraulic Characteristics in the Rod Bundles with Grid Spacer