Abstract:Various defects during the manufacture of a high-energy laser monocrystalline silicon reflector will increase the energy absorption rate of the substrate and worsen the optical properties. Micron-scale or larger manufacturing defects have been inhibited by mechanism study and improvement in technology, but the substrate performance still fails to satisfy the application demand. We focus on the changes in the optical properties affected by nanoscale and Angstrom lattice defects on the surface of monocrystalline silicon and acquire the expected high reflectivity and low absorptivity through deterministic control of its defect state. Based on the first principles, the band structures and optical properties of two typical defect models of monocrystalline silicon—namely, atomic vacancy and lattice dislocation—were analyzed by molecular dynamics simulations. The results showed that the reflectivity of the vacancy defect was higher than that of the dislocation defect, and elevating the proportion of the vacancy defect could improve the performance of the monocrystalline silicon in infrared (IR) band. To verify the results of simulations, the combined Ion Beam Figuring (IBF) and Chemical Mechanical Polishing (CMP) technologies were applied to introduce the vacancy defect and reduce the thickness of defect layer. After the process, the reflectivity of the monocrystalline silicon element increased by 5% in the visible light band and by 12% in the IR band. Finally, in the photothermal absorption test at 1064 nm, the photothermal absorption of the element was reduced by 80.5%. Intense laser usability on the monocrystalline silicon surface was achieved, and the effectiveness and feasibility of deterministic regulation of optical properties were verified. This concept will be widely applied in future high-energy laser system and X-ray reflectors.

Excimer Laser Reflectors

Damage Thresholds of (Zro2-Y2o3)/sio2 Reflectors Used for Xecl Lasers

Antireflective Coatings Used for High-Power Co2-Laser

Omnidirectional Photonic Crystal Reflector Used in Ultraviolet Region

Traceless Mitigation of Laser Damage Precursors on a Fused Silica Surface by Combining Reactive Ion Beam Etching with Dynamic Chemical Etching

Silicon Reflectors for External Cavity Lasers Based on Ring Resonators

Low-loss Antireflection for Laser System

Storage ring free-electron lasing at 176 nm--dielectric mirror development for vacuum ultraviolet free-electron lasers

Optimum End Reflectivity in External Semiconductor Lasers

Evaluation of Flashlamp Reflectors for the Atomic Iodine Photodissociation Laser

Research Of Multi-Band Laser High Reflection Mirror

Design studies for distributed Bragg reflectors for short-cavity edge-emitting lasers

&Lt;title>high-Power Excimer Laser and Application</title>

Preparation of Ultralow Loss Mirrors with Reflectivity of over 99.9968%

Diamond Mirrors for High-Power Lasers

Compact high-precision soft X-ray and extreme ultraviolet reflectometer

Damage threshold measurements on EUV optics using focused radiation from a table-top laser produced plasma source

Enhancement of the Load Capacity of High-Energy Laser Monocrystalline Silicon Reflector Based on the Selection of Surface Lattice Defects

Antireflection microstructures on ZnSe for mid- and far-IR fabricated by femtosecond laser ablation assisted with wet chemical etching

Encapsulated subwavelength grating as a quasi-monolithic resonant reflector

Lasers, Waveguides And Fibers For 3.0 Mu M Medical Applications.