Abstract:Various defects during the manufacture of a high-energy laser monocrystalline silicon reflector will increase the energy absorption rate of the substrate and worsen the optical properties. Micron-scale or larger manufacturing defects have been inhibited by mechanism study and improvement in technology, but the substrate performance still fails to satisfy the application demand. We focus on the changes in the optical properties affected by nanoscale and Angstrom lattice defects on the surface of monocrystalline silicon and acquire the expected high reflectivity and low absorptivity through deterministic control of its defect state. Based on the first principles, the band structures and optical properties of two typical defect models of monocrystalline silicon—namely, atomic vacancy and lattice dislocation—were analyzed by molecular dynamics simulations. The results showed that the reflectivity of the vacancy defect was higher than that of the dislocation defect, and elevating the proportion of the vacancy defect could improve the performance of the monocrystalline silicon in infrared (IR) band. To verify the results of simulations, the combined Ion Beam Figuring (IBF) and Chemical Mechanical Polishing (CMP) technologies were applied to introduce the vacancy defect and reduce the thickness of defect layer. After the process, the reflectivity of the monocrystalline silicon element increased by 5% in the visible light band and by 12% in the IR band. Finally, in the photothermal absorption test at 1064 nm, the photothermal absorption of the element was reduced by 80.5%. Intense laser usability on the monocrystalline silicon surface was achieved, and the effectiveness and feasibility of deterministic regulation of optical properties were verified. This concept will be widely applied in future high-energy laser system and X-ray reflectors.

Encapsulated subwavelength grating as a quasi-monolithic resonant reflector

Monolithic Integration of a High-Quality Factor Lithium Niobate Microresonator with a Free-Standing Membrane Waveguide Using Femtosecond Laser Assisted Ion Beam Writing (FLAIBW)

Diffractively coupled Fabry-Perot resonator with power-recycling

High reflectivity high-Q micromechanical Bragg mirror

Flat Dielectric Grating Reflectors with High Focusing Power

All-dielectric High-Efficiency Reflection Gratings Made with Multilayer Thin-Film Coatings

Design of High-Quality Reflectors for Vertical Nanowire Lasers on Si

From membrane-in-the-middle to mirror-in-the-middle with a high-reflectivity sub-wavelength grating

Analysis of High-Order Surface Gratings Based on Micron Lasers on Silicon

Surface Bragg gratings for high brightness lasers

All-reflective coupling of two optical cavities with 3-port diffraction gratings

Broadband near-infrared reflector based on double-layer subwavelength gratings

High-reflectivity, high-Q micromechanical membranes via guided resonances for enhanced optomechanical coupling

Design of high-quality reflectors for vertical III–V nanowire lasers on Si

Enhancement of the Load Capacity of High-Energy Laser Monocrystalline Silicon Reflector Based on the Selection of Surface Lattice Defects

Design of High-Efficiency Dielectric Reflection Gratings

Characterization of anti-reflection structures fabricated via laser micro/nano-processing

Silicon-based fabry-perot microcavity with bragg grating reflectors

Infrared diffractive filtering for extreme ultraviolet multilayer Bragg reflectors

Concept of Inverted Refractive-Index-Contrast Grating Mirror and Exemplary Fabrication by 3D Microprinting

Light trapping PMMA planar ridged waveguide on a laser textured silicon substrate for ultra-low reflectivity