Influence of tool parameters on tool wear in two-roll cross-wedge rolling

Jie Zhou,Chuan Xiao,Yingyan Yu,Zhi Jia

DOI: https://doi.org/10.1007/s00170-012-4213-1

IF: 3.563

2012-01-01

The International Journal of Advanced Manufacturing Technology

Abstract:A simulation model for two-wedge two-roll cross-wedge rolling was presented by using three-dimensional rigid plastic finite element method. Based on the simulation results, the influence of three tool parameters—the forming angle α , the spreading angle β , and the area reduction Ψ on tool wear—is ascertained and discussed. The study results indicate that the tool wear depth increases with larger α , β , and Ψ . Simultaneously, tool wear can be improved under the condition of α = 28°, β = 8°, Ψ 1 = 48.6 %, and Ψ 2 = 53.3 %. Subsequently, blank forming for the engine connect rod was produced in the factory and statistical data from the factory manifests the feasibility of study results.