Abstract:To optimise the benefits of the deep-rolling process in the service life context of treated components, the process application must be investigated. In addition to the reduction in surface roughness and near-surface material strengthening, compressive residual stresses are introduced, which are primarily responsible for the increase in service life for components, especially in the case of high-strength steel materials. A numerical parameter sensitivity analysis is performed in order to investigate the introduced residual stresses in detail. For this purpose, a validated deep-rolling simulation model is used, which replicates the deep rolling of a railway axle made of the high-strength steel material 34CrNiMo6. The model is based on an elastic-plastic Chaboche material model parameterised on uniaxial tensile and LCF test results and validated with residual stress measurements. Using this model as a basis, the effect of the main process parameters deep-rolling force, feed rate, friction coefficient, number of overruns, tool geometry, and shaft geometry on the resulting residual stress state are investigated. The results reveal that the deep-rolling force has the most significant influence on the introduced residual stress state and should therefore be highlighted. In the case of applying a deep-rolling force of more than 10 kN, maximum compressive residual stresses of around − 1000 MPa are introduced, and a strong saturating behaviour is shown. Maximum compensating tensile residual stresses of + 100 MPa occur below the surface. The main influence of the deep-rolling force is the effective depth achieved, which is determined by the depth of the zero crossing. This varies from 1 mm with an applied force of 2 kN to more than 3.5 mm with 20 kN. Furthermore, the results are analysed to conclude suggestions for the process's applicability, and a proposal for an optimised deep-rolling treatment is presented. There multiple deep rolling with decreased deep-rolling forces is used to achieve a comparably optimised residual stress state. In summary, with the presented results, a contribution to a deeper understanding of the deep-rolling process can be achieved; the influence of the most important process parameters on the residual stress in-depth profiles is established; an optimisation proposal is presented; and correlations are found. Thus, the base work for further fatigue strength assessments and the optimisation of the deep-rolling process regarding the increase of service is laid.

Research on the Corner Stress of Dog-Bone Shaped Workpiece During Flat-Spread Rolling

Evolution of Residual Stress Based on Curvature Coupling in Multi-Roll Levelling

Numerical Analysis on Flatness Adjusting Performance of Hot Wide Strip Temper Mill with Small-Diameter Work Rolls

Theoretical Study of Asymmetric Bending Force on Metal Deformation in Cold Rolling

The Cracks on Slab Corner During Hot Rolling Process

Precise local deformation control for UHSS thin-walled component in roll forming

Research on the Mechanism and Processability of Roll Forming

Research on quarter-wave control in DP980 steel during cold rolling based on multi-pass simulation

Tri-dimensional Elastic-Plastic Fem of Rolling Force During Strip Finishing Rolling Process

Influence of the rotational speed ratio of rollers on the three-dimensional surface rolling process

Analytical and Finite Element Analysis of the Rolling Force for the Three-Roller Cylindrical Bending Process

Calculation method and analysis of residual stress in the strip bending roller straightening process

The effect of highly elongated micro-contacts on rolling contact stress field

Research on roll contour and control strategy for edge drop control of high-strength steel in the cold rolling precision mill

Analysis of the Asymmetrical Rolling of Ultra-Thin Strips Considering Elastic Deformation of the Strips

Analysis of stress-strain in the partial heating roll forming process of high strength square hollow steel sections

Variation laws and influencing factors of lateral spread of the cold-rolled thin steel in rolling process

FEM simulation of thermo-mechanical stress and thermal fatigue life assessment of high-speed steel work rolls during hot strip rolling process

Residual stress control of hot-rolled strips during run-out table cooling

Mathematical modeling and simulated analysis of metal flow behavior during the FGC of ESP rolling process

Numerical parameter sensitivity analysis of residual stresses induced by deep rolling for a 34CrNiMo6 steel railway axle