Abstract:Abstract Central cracking in cross-wedge-rolled workpieces results in high wastage and economic loss. Recent cross-wedge rolling tests on two batches of steel showed that one batch formed central cracks, while the other was crack-free. The batches were both nominally of the same chemical composition and thermomechanical treatment history. In addition, both batches had passed all the standard quality assessments set for conventional forging processes. It was suspected that the different cracking behaviours were due to differences in microstructure between the two as-received steel billets, and the material in cross-wedge rolling (CWR) was more sensitive to the initial microstructure compared with other forging processes due to its specific loading condition including ostensibly compression and large plastic strain. Nevertheless, no previous study of this important problem could be identified. The aim of this study is, therefore, to identify the key microstructural features determining the central crack formation behaviour in CWR. The hot workability of the as-received billets was studied under uniaxial tensile conditions using a Gleeble 3800 test machine. Scanning electron microscope with energy-dispersive X-ray spectroscopy and electron backscatter diffraction was applied to characterise, quantitatively analyse, and compare the chemical composition, phase, grain, and inclusions in these two billets, both at room temperature and also at the CWR temperature (1080 °C). Non-metallic inclusions (oxides, sulphides, and silicates) in the billets were determined to be the main cause of the reported central cracking problem. The ductility of the steels at both room and elevated temperatures deteriorated markedly in the presence of the large volumes of inclusions. Grain boundary embrittlement occurred at the CWR temperature due to the aggregation of inclusions along the grain boundaries. It is suggested that a standard on specifying the inclusion quantity and size in CWR billets be established to produce crack-free products.

Feasibility Analysis of Cross Wedge Rolling (CWR) of Hexahedral Billet

Three-dimensional rigid–plastic finite element simulation for the two-roll cross-wedge rolling process

The Application of Finite Element Method for Analysis of Cross-Wedge Rolling Processes-A Review

Numerical and experimental research on warm cross wedge rolling of hollow shafts with corrugated surface

Investigation and prediction of central cracking in cross wedge rolling

Novel evaluation method for metal workability during cross wedge rolling process

Microstructural effects on central crack formation in hot cross-wedge-rolled high-strength steel parts

Numerical and experimental analysis of defects control in cross wedge rolling for titanium alloy workpieces

A Multi-scale Modelling by Coupling Cellular Automata with Finite Element Method and Its Application on Cross-Wedge Rolling

Study on manufacturing of special-shaped ends blank for cross wedge rolling without stub bar

Investigation on the inner hole spiral-groove of cross wedge rolling of hollow shafts with mandrel

Design and simulation of cross wedge rolling process for hollow motor shaft

Buckling Defect Optimization of Constrained Ring Rolling of Thin-Walled Conical Rings with Inner High Ribs Combining Response Surface Method with FEM

Numerical Analysis and Parameter Optimization of Wear Characteristics of Titanium Alloy Cross Wedge Rolling Die

Finite Element Simulation and Microstructural Analysis of Roll Forming for DP590 High-Strength Dual-Phase Steel Wheel Rims

Analysis of rolling force and layer thickness in bimetal clad rolling

Investigation on the formation of central damage in cross wedge rolling of GH4169 alloy

Mathematical modeling and simulated analysis of metal flow behavior during the FGC of ESP rolling process

Research on the Mechanism and Processability of Roll Forming

The Mechanism of Forming Hollow Shafts with Constant Wall Thickness by Three-Roll Skew Rolling

An Efficient Multi-Scale Modeling Method that Reveals Coupled Effects Between Surface Roughness and Roll-Stack Deformation in Cold Sheet Rolling