Abstract:Cross wedge rolling has the advantages of high production efficiency, good product quality, high material utilization, environmental protection, and low cost. It is one of the best processing methods for producing shaft blanks. In this paper, a cross wedge rolling die of TC4 titanium alloy is studied. Based on the Archard wear model, a modified model suitable for cross wedge rolling die wear analysis is derived through finite element simulation. Then, the modified Archard wear model is imported into Deform-3D software for finite element analysis. Orthogonal experimental design is used to combine and analyze different process parameters. Finally, the beetle antennae search (BAS)-genetic algorithm (GA)-back propagation neural network (BPNN) algorithm is used to predict the degree of die wear and to optimize the simulation parameters, which can acquire the process parameters that have the least impact on die wear. The results show that the wear distributions of cross wedge rolling tools is uneven. In general, the most serious areas are basically concentrated in the wedge-shaped inclined plane and rectangular edge lines. The reason is that the tangential force and radial force received by the die are relatively large, which leads to increased wear. Moreover, the temperature change is most severe on the wedge-shaped ridge line. When in contact with the workpiece, the temperature rises sharply, which makes the local temperature rise, the mold hardness decrease, and the wear accelerate. Through response surface method (RSM) analysis, it is concluded that the deformation temperature is the main factor affecting wear depth, followed by the forming angle, and that there is an interaction between the two factors. Finally, the feasibility of the BAS-GA-BP algorithm for optimizing the wear behavior of dies is verified, which provides a new process parameter optimization method for the problem of die wear in the cross wedge rolling process.

Study on manufacturing of special-shaped ends blank for cross wedge rolling without stub bar

Parameters Optimization of Tailor Welded Blank Forming Process

Feasibility Analysis of Cross Wedge Rolling (CWR) of Hexahedral Billet

Design and simulation of cross wedge rolling process for hollow motor shaft

Novel evaluation method for metal workability during cross wedge rolling process

Study on near-net forming technology for bars by axial feed skew rolling based on taper-end billets

Research on the Law of Affecting the Quality of forging Metallurgy Quality on the Quality of Wedge Horizontal Rolling Mold

Three-dimensional rigid–plastic finite element simulation for the two-roll cross-wedge rolling process

Numerical and experimental analysis of defects control in cross wedge rolling for titanium alloy workpieces

Investigation on the inner hole spiral-groove of cross wedge rolling of hollow shafts with mandrel

Numerical Analysis and Parameter Optimization of Wear Characteristics of Titanium Alloy Cross Wedge Rolling Die

Research on the Mechanism and Processability of Roll Forming

The Application of Finite Element Method for Analysis of Cross-Wedge Rolling Processes-A Review

A Systematic Study on the Effects of Process Parameters on Spinning of Thin-Walled Curved Surface Parts With 2195 Al-Li Alloy Tailor Welded Blanks Produced by FSW

Towards a blank design method for manufacturing big-tapered profiled ring disk by spinning-rolling process

Numerical and experimental research on warm cross wedge rolling of hollow shafts with corrugated surface

Implementing approach of rolling process for inner spline sleeve with medium diameter: radial-feed rolling and through-feed rolling

Forming characteristics and mechanism of double-roll rotary forging for large-diameter and thin-walled metal discs

The Mechanism of Forming Hollow Shafts with Constant Wall Thickness by Three-Roll Skew Rolling

An innovative spinning-rolling process and its intelligent FE modelling for big-tapered profiled ring disk

Blank wedge cross rolling precise blank-forging die-forging forming process for engine camshaft of internal combustion engine