Abstract:The temperature field distribution during the growth of crystalline silicon by the directional solidification (DS) method is an important factor affecting the growth rate, the shape of the melt-crystal (m-c) interface, and thermal stress. To solve the problem of m-c interface convexity at the early stage of crystal growth caused by supercooling at the bottom center of silicon ingot during DS. In this paper, a two dimensional (2D) global transient numerical model based on a large-size ALD-G7 (G7) crystalline silicon ingot furnace is established and experimentally verified. Based on the model, the influence of different bottom thermal gate moving process curves on the convexity of the m-c interface at the early stage was studied, with emphasis on the changes in temperature field, m-c interface, and thermal stress at the early stage of crystal growth. We have designed three cases, case 1 uses the original moving process curve of bottom thermal gate, case 2 and case 3 adjust the process curve to 0.95 and 0.9 of the original ratio, respectively. The numerical simulation results show that compared with case 1, the average heat dissipation at the bottom of the silicon ingot in case 2 and case 3 is reduced by 2.7 kW·m −2 and 4 kW·m −2 , and the maximum thermal stress is also reduced by 3 MPa and 4 MPa, separately. The maximum convexity of the interface is reduced by 25 mm and 20 mm, and the convexity is reduced by 55% and 44% on average, respectively.

Determination and Controlling of Crystal Growth Rate during Silicon Purification by Directional Solidification

Numerical Simulation of Directional Solidification Process for the Polycrystalline Silicon Ingot

A High-Efficiency and Energy-Saving Method for Purifying Industrial Silicon for Silicone Use

In situ observation and numerical analysis of temperature gradient effects on growth velocity during directional solidification of silicon

Optimization of the Thermal Field of 8-Inch SiC Crystal Growth by PVT Method with “3 Separation Heater Method”

Effects of Solution Height and Crystal Rotation on the Solution Flow Behavior in the Top-Seeded Solution Growth of SiC Single Crystals

Numerical Investigation on the Effect of Thermal Gate Moving Rate on Directional Solidification Process

Oxygen and Nitrogen Transfer in Furnaces in Crystal Growth of Silicon by Czochralski and Directional Solidification Processes

Numerical Simulation of a Novel Method for PVT Growth of SiC by Adding a Graphite Block

Effect of melt flow on impurity distribution in directional solidification of silicon solar cells

Diameter-Controlled Czochralski Growth of Silicon Crystals

Numerical analysis of thermohydraulic behavior in a directional solidification furnace

Transport Mechanism of Fe Impurity During the Purification of Silicon by Electromagnetic Directional Solidification of Hypereutectic Si–Ti Melt

Optimization of thermal field of 150 mm SiC crystal growth by PVT method

Numerical Investigation of Bottom Grille for Improving Large-Size Silicon Quality in Directional Solidification Process

Effect of Crystal Rotation on Melt Convection and Resistivity Distribution in 200 mm Floating Zone Silicon Single Crystal Growth

Thermal system design and optimization of an industrial silicon directional solidification system

Modeling and improvement of silicon ingot directional solidification for industrial production systems

Control of the Gas Flow in an Industrial Directional Solidification Furnace for Production of High Purity Multicrystalline Silicon Ingots

Silicon Carbide Particle Formation/engulfment During Directional Solidification of Silicon

The Effect of Temperature on Silicon Nucleation from Melt in Seed-assisted Growth — a Molecular Dynamics Study