Abstract:The temperature field distribution during the growth of crystalline silicon by the directional solidification (DS) method is an important factor affecting the growth rate, the shape of the melt-crystal (m-c) interface, and thermal stress. To solve the problem of m-c interface convexity at the early stage of crystal growth caused by supercooling at the bottom center of silicon ingot during DS. In this paper, a two dimensional (2D) global transient numerical model based on a large-size ALD-G7 (G7) crystalline silicon ingot furnace is established and experimentally verified. Based on the model, the influence of different bottom thermal gate moving process curves on the convexity of the m-c interface at the early stage was studied, with emphasis on the changes in temperature field, m-c interface, and thermal stress at the early stage of crystal growth. We have designed three cases, case 1 uses the original moving process curve of bottom thermal gate, case 2 and case 3 adjust the process curve to 0.95 and 0.9 of the original ratio, respectively. The numerical simulation results show that compared with case 1, the average heat dissipation at the bottom of the silicon ingot in case 2 and case 3 is reduced by 2.7 kW·m −2 and 4 kW·m −2 , and the maximum thermal stress is also reduced by 3 MPa and 4 MPa, separately. The maximum convexity of the interface is reduced by 25 mm and 20 mm, and the convexity is reduced by 55% and 44% on average, respectively.

Numerical Investigation of Bottom Grille for Improving Large-Size Silicon Quality in Directional Solidification Process

Numerical Simulation of Directional Solidification Process for the Polycrystalline Silicon Ingot

Numerical Investigation on the Effect of Thermal Gate Moving Rate on Directional Solidification Process

Numerical and experimental investigation of octagonal thermal field for improving multi-crystalline silicon ingot quality

Numerical Simulation of a Novel Method for PVT Growth of SiC by Adding a Graphite Block

Optimization of the Thermal Field of 8-Inch SiC Crystal Growth by PVT Method with “3 Separation Heater Method”

Influence of Radiation Heat Transfer on Mc-Si Ingot during Directional Solidification: A Numerical Investigation

Influence of Inner Crucible Radius Variation on the Thermal Field and Oxygen Transport in the Melt During the Growth of Silicon by Continuous Czochralski Method

A New Design of Side Heater for 3D Solid-liquid Interface Improvement in G8 Directional Solidification Silicon Ingot Growth

Role of Longitudinal Temperature Gradients in Eliminating Interleaving Inclusions in Casting of Monocrystalline Silicon Ingots

Effect of Silicon Nitride Coated Carbon Crucible on Multi-Crystalline Silicon Ingot during Directional Solidification Process: Numerical Simulation

Numerical Simulation of Β-Ga2o3 Single Crystal Growth by Czochralski Method with an Insulation Lid

Numerical Investigation of the VB Growth of CaF2 Crystal with Supercooled Crucible Wall

Design and numerical analysis of a novel argon gas tube to reduce impurities in large size casting crystalline silicon furnace

Super-gravity field assisted homogeneous distribution of sub-micron eutectic Si in Al-Si alloy

Optimization of thermal field of 150 mm SiC crystal growth by PVT method

Numerical analysis of thermohydraulic behavior in a directional solidification furnace

Thermal system design and optimization of an industrial silicon directional solidification system

In situ observation and numerical analysis of temperature gradient effects on growth velocity during directional solidification of silicon

Control of the Gas Flow in an Industrial Directional Solidification Furnace for Production of High Purity Multicrystalline Silicon Ingots

Optimal Cooling System Design for Increasing the Crystal Growth Rate of Single-Crystal Silicon Ingots in the Czochralski Process Using the Crystal Growth Simulation