Abstract:The crack tip constraint effect should be considered in the fracture assessment of structures with cracks, and the in-plane constraint and out-of-plane constraint should be illustrated simultaneously for the three-dimensional cracks in practical engineering structures. The constraint effect of central cracked plate (CCP) specimens with I-II mixed mode crack under uniaxial compression has been investigated quantitatively in present work. The relationship between T-stress components (Tx, Ty, Txy) and in-plane constraint parameter T11 has been established. The effects of a wide range of in-plane and out-of-plane geometrical configurations (including relative crack length a/W and thickness to width ratio t/W), material parameters (including elastic modulus E and Poisson's ratio ν), crack inclination angle β and friction coefficient μ corresponding to stress intensity factors (K), in-plane constraint parameter T11 and out-of-plane constraint parameters T33 and Tz at the crack tip have been calculated and discussed theoretically and numerically. It demonstrates that the constraint parameters can effectively express the stress-strain field at the crack tip. The relative crack length a/W has an influence on the in-plane and out-of-plane constraint parameters, and the thickness to width ratio t/W mainly affects the out-of-plane constraint parameters T33 and Tz. The out-of-plane constraint parameters should be considered for long cracks. There is a loss of out-of-plane constraint under compression when t/W less than or equal to 0.9, which can be much more directly and evidently investigated through the analysis of Tz than T33. The empirical equations for KII, T11 and Tz have been obtained according to theoretical analysis and simulation results, which are convenient and effective for application.

Three-dimensional finite element analyses of in-plane and out-of-plane creep crack-tip constraints for different specimen geometries

Effect of constraint on creep fracture toughness of a Cr-Mo-V steel

Instrumented indentation measurements of residual stresses around a crack tip under single tensile overloads

Characterization of creep constraint effect for brazed joint specimens at crack tip by new constraint parameter A

A new creep-fatigue crack growth model and a correlation of the creep-fatigue crack growth rate with unified constraint parameter

Constraint modified time dependent failure assessment diagram (TDFAD) based on <i>C</i>(<i>t</i>)-<i>A</i><sub>2</sub>(<i>t</i>) theory for creep crack

Research on Fatigue-Creep Interaction Damage of Steel 1.25Cr0.5mo

An Insight into the Creep-Fatigue Damage Localization in Welded Joints Based on Crystal Plasticity Finite Element Method

Numerical Investigations on the Effects of T-stress in Creep Crack

3D front tip fields in creeping solids under constraint effects: a higher-order asymptotic solution

Creep Behaviors Calculated by Varying Material Constants Obtained from Different Stress Regions for a Closed-End P91 Pipe

Effect and mechanism of constraint on creep crack growth behavior of GH3535 alloy

Evaluation of the Effect of Various Prior Creep-Fatigue Interaction Damages on Subsequent Tensile and Creep Properties of 9%cr Steel

Numerical Investigations on the Effects of T-Stress in Mode I Creep Crack

Creep fracture parameter C* solutions for semi‐elliptical surface cracks in plates under tensile and bending loads

T-stresses solution and out-of-plane constraint for central cracked plate (CCP) with I-II mixed mode crack under uniaxial compression

Fatigue-Creep Interaction Of P92 Steel And Modified Constitutive Modelling For Simulation Of The Responses

A Creep Constitutive Model, Based on Deformation Mechanisms and Its Application to Creep Crack Growth

Assessment of Creep Behavior Using a Damage-Coupled Model for Martensitic Stainless Steel

A Higher-Order Asymptotic Solution for 3d Sharp V-Notch Front Tip Fields in Creeping Solids

Characterization of Mismatch Constraint Effect for the Central Crack Plate under Biaxial Loading