Abstract:The crack tip constraint effect should be considered in the fracture assessment of structures with cracks, and the in-plane constraint and out-of-plane constraint should be illustrated simultaneously for the three-dimensional cracks in practical engineering structures. The constraint effect of central cracked plate (CCP) specimens with I-II mixed mode crack under uniaxial compression has been investigated quantitatively in present work. The relationship between T-stress components (Tx, Ty, Txy) and in-plane constraint parameter T11 has been established. The effects of a wide range of in-plane and out-of-plane geometrical configurations (including relative crack length a/W and thickness to width ratio t/W), material parameters (including elastic modulus E and Poisson's ratio ν), crack inclination angle β and friction coefficient μ corresponding to stress intensity factors (K), in-plane constraint parameter T11 and out-of-plane constraint parameters T33 and Tz at the crack tip have been calculated and discussed theoretically and numerically. It demonstrates that the constraint parameters can effectively express the stress-strain field at the crack tip. The relative crack length a/W has an influence on the in-plane and out-of-plane constraint parameters, and the thickness to width ratio t/W mainly affects the out-of-plane constraint parameters T33 and Tz. The out-of-plane constraint parameters should be considered for long cracks. There is a loss of out-of-plane constraint under compression when t/W less than or equal to 0.9, which can be much more directly and evidently investigated through the analysis of Tz than T33. The empirical equations for KII, T11 and Tz have been obtained according to theoretical analysis and simulation results, which are convenient and effective for application.

Unified Characterization of In-Plane and Out-Of-Plane Creep Constraint Based on Crack-Tip Equivalent Creep Strain

Experimental Study of Unidirectional Compression Creep in K0 State for Rockfill Material

A new creep-fatigue crack growth model and a correlation of the creep-fatigue crack growth rate with unified constraint parameter

Characterization of creep constraint effect for brazed joint specimens at crack tip by new constraint parameter A

Characterization of Mismatch Constraint Effect for the Central Crack Plate under Biaxial Loading

Research on Multiaxial Creep Properties of P92 Steel Based on Improved KR Creep Constitutive Model

3D front tip fields in creeping solids under constraint effects: a higher-order asymptotic solution

T-stresses solution and out-of-plane constraint for central cracked plate (CCP) with I-II mixed mode crack under uniaxial compression

Load-independent creep constraint analysis and solutions for surface cracks in pressurized pipes

Constraint modified time dependent failure assessment diagram (TDFAD) based on <i>C</i>(<i>t</i>)-<i>A</i><sub>2</sub>(<i>t</i>) theory for creep crack

Effect of constraint on creep fracture toughness of a Cr-Mo-V steel

Unified creep constraint parameter solutions for surface cracks in plates under tensile and bending loads

Effect and mechanism of constraint on creep crack growth behavior of GH3535 alloy

Impact of out‐of‐plane constraint on creep crack growth behavior of M174+ aluminum alloys by nano‐computed tomography (CT)

Numerical Investigations on the Effects of T-Stress in Mode I Creep Crack

Mismatch Constraint Effect of Creep Crack With Modified Boundary Layer Model

The Interacting Effect for Collinear Cracks Near Mismatching Bimaterial Interface under Elastic Creep

A Creep Constitutive Model, Based on Deformation Mechanisms and Its Application to Creep Crack Growth

Mismatch Constraint Effect for Bimaterial Interfacial Creep Crack

Effects of nonproportional loading and residual stress on creep crack tip fields

Creep crack growth prediction using a damage based approach