Abstract:The lifetime of GaAs photocathodes in polarized electron guns is limited due to the delicate activation layer. An atomically clean and smooth GaAs surface is needed to deposit a robust activation layer, such as Cs2Te, with longer lifetime compared to traditional (Cs,O) activation. A previous experiment with Cs2Te activation on GaAs used heat cleaning temperatures around 400°C to avoid an increase in surface roughness [Bae et al., Appl. Phys. Lett. 112, 154101 (2018)]. High-temperature heat cleaning around 580°C, which results in a relatively contamination-free surface, could be one possible way to improve quantum efficiency. However, one should be cautious about surface roughness degradation during high-temperature heat cleaning. In this paper, we report results of surface roughness measurements on native, heat cleaned, and (Cs,O) activated GaAs photocathodes under vacuum. The results, measured by ultrahigh vacuum scanning tunneling microscopy, show that the surface roughness improves as the heat cleaning temperature is increased, by at least a factor of three for 580°C heat cleaning, compared to the native sample. Activation with (Cs,O) is shown to increase surface roughness by a factor of four compared to a 580°C heat cleaned sample. This confirms that high-temperature heat cleaning can be useful for depositing good quality robust activation layers on GaAs. We also report chemical analysis for each step of preparation for p-doped GaAs photocathodes using X-ray photoelectron spectroscopy (XPS), angle-resolved XPS, and ultraviolet photoelectron spectroscopy. Our results indicate that the (Cs,O) activation layer forms a sandwich structure consists of Cs and oxygen. We found no formation of any specific compound such as Cs2O or Cs11O3.

Lifetime Test of Photoemission from Cs3sb Photocathode Coated with W or Cr Film

Purification and Improved Photoelectric Properties of Lead-Free Perovskite Cs3Bi2Br9 Crystals

Influence of Cs, O Activation on Spectral Response Characteristics of GaAsP Photocathode

Photosensitive Post Tuning of Chalcogenide Te20As30Se50 Narrow Bandpass Filters

Research on Antimony-Cesium Photocathode Based on Tungsten Substrate

Laser-driven Pulsed Emission and Plasma Formation of Cs3Sb Photocathodes

Atomically smooth films of CsSb: a chemically robust visible light photocathode

Fabrication and electrical characterization of planar lighting devices with Cs3Sb photocathode emitters

Cold electron beams from cryo-cooled, alkali antimonide photocathodes

Performance of Bialkali Photocathode in DC-SRF Photoinjector

Key technologies towards high quantum efficiency K2CsSb photocathode

Durability and Photo-Electric Characteristics of a Mille-Feuille Structured Amorphous Selenium (A-Se)–arsenic Selenide (as2se3) Multi-Layered Thin Film

Application of quasi-steady state photoconductance technique to lifetime measurements on c-Ge substrates

Revisiting Heat Treatment and Surface Activation of GaAs Photocathodes: in Situ Studies Using Scanning Tunneling Microscopy and Photoelectron Spectroscopy

Investigation on the stability of Na2KSb photocathode driven by laser pulses

Influence of Pinch Effect on the Lifetime of a 2MW Silicon Carbide Photoconductive Semiconductor Switch

Kinetically regulated growth of Cs3Cu2I5 single-crystalline thin films for highly responsive and stable deep-ultraviolet photodetectors

ACCELERATED LIFE TEST STUDIES OF NEW COATED DISPENSER CATHODES

Research on Fabrication Recipe of High Quantum Efficiency K2CsSb Photocathode

Degradation factors of a new long-life cathode

Performance of Csi Photocathodes in Liquid Xe, Kr, and Ar