Co-electroplated Kesterite Bifacial Thin-Film Solar Cells: A Study of Sulfurization Temperature
Jie Ge,Junhao Chu,Yanfa Yan,Jinchun Jiang,Pingxiong Yang
DOI: https://doi.org/10.1021/acsami.5b01641
2015-05-20
Abstract:Earth-abundant material, kesterite Cu2ZnSnS4 (CZTS), demonstrates the tremendous potential to serve as the absorber layer for the bifacial thin-film solar cell. The exploration of appropriate sulfurization conditions including annealing temperature is significant to gain insight into the growth mechanism based on the substrates using transparent conductive oxides (TCO) and improve device performance. The kesterite solar absorbers were fabricated on ITO substrates by sulfurizing co-electroplated Cu-Zn-Sn-S precursors in argon diluted H2S atmosphere at different temperatures (475-550 °C) for 30 min. Experimental proof, including cross-section scanning electron microscopy, X-ray photoelectron spectroscopy, X-ray diffraction, UV-vis-NIR transmission spectrum, and Raman and far-infrared spectroscopy, is presented for the crystallization of CZTS on an ITO substrate and the interfacial reaction between the ITO back contact and CZTS absorber. The complete conversion of precursor into CZTS requires at least 500 °C sulfurization temperature. The aggressive interfacial reaction leading to the out-diffusion of In into CZTS to a considerable extent, formation of tin sulfides, and electrically conductive degradation of ITO back contact occurs at the sulfurization temperatures higher than 500 °C. The bifacial devices obtained by 520 °C sulfurization exhibit the best conversion efficiencies and open circuit voltages. However, the presence of non-ohmic back contact (secondary diode), the short minority lifetime, and the high interfacial recombination rates negatively limit the open circuit voltage, fill factor, and efficiency, evidenced by illumination/temperature-dependent J-V, frequency-dependent capacitance-voltage (C-V-f), time-resolved PL (TRPL), and bias-dependent external quantum efficiency (EQE) measurements.