Abstract:Solar cells based on kesterite-type $Cu_2ZnSnS_4$ (CZTS) thin films were fabricated using a chemical route to prepare the $CZTS$ films, consisting in sequential deposition of $Cu_2SnS_3$ (CTS) and $ZnS$ thin films followed by annealing at $550^\circ C$ in nitrogen atmosphere. The $CTS$ compound was prepared in a one-step process using a novel chemical procedure consisting of simultaneous precipitation of $Cu_2S$ and $SnS_2$ performed by diffusion membranes assisted $CBD$ (chemical bath deposition) technique. Diffusion membranes were used to optimize the kinetic growth through a moderate control of release of metal ions into the work solution. As the conditions for the formation in one step of the $Cu_2SnS_3$ compound have not yet been reported in literature, special emphasis was put on finding the parameters that allow growing the $Cu_2SnS_3$ thin films by simultaneous precipitation of $Cu_2S$ and $SnS_2$. For that, we propose a methodology that includes numerical solution of the equilibrium equations that were established through a study of the chemical equilibrium of the system $SnCl_2$, $Na_3C_6H_5O_7\cdot 2H2O$, $CuCl_2$ and $Na_2S_2O_3\cdot5H_2O$. The formation of thin films of $CTS$ and $CZTS$ free of secondary phases grown with a stoichiometry close to that corresponding to the $Cu_2SnS_3$ and $Cu_2ZnSnS_4$ phases, was verified through measurements of X-ray diffraction $(XRD)$ and Raman spectroscopy. Solar cell with an efficiency of $4.2%$, short circuit current of $16.2 mA/cm^2$ and open-circuit voltage of 0.49 V was obtained.

Preparation and photovoltaic characterization of Cu2ZnSnS4 thin films fabricated by electrodeposition of alloy precursor followed by annealling

Formation of Alloyed Cu2CoxZn1-xSn(S,Se)4 Absorption Layer and Its Application in Solar Cells.

Formation of Alloyed Cu2Cox Zn1-x Sn(S,Se)4 Absorption Layer and Its Application in Solar Cells

Low-cost Fabrication of Cu 2 ZnSnS 4 Thin Films for Solar Cell Absorber Layers

Preparation And Characterization Of Cu2znsns4 Thin Films And Solar Cells Fabricated From Quaternary Cu-Zn-Sn-S Target

Preparation and Characterization of Cuins2 Thin Films for Solar Cells by Chemical Bath Deposition

Synthesis and characterization of CZTS and Cu2-xAgxZnSnS4 thin films for the application of solar cells

Synthesis and Characterization of Hydrazine Solution Processed Cu12Sb4S13 Film

Impact of Sol–gel Precursor Treatment with Preheating Temperature on Properties of Cu2ZnSnS4 Thin Film and Its Photovoltaic Solar Cell

Preparing Cu2ZnSnSe4 thin film solar cells based on selenium containing precursors

Preparation of High-Quality Cu2ZnSnS4 Thin Films for Solar Cells Via the Improvement of Sulfur Partial Pressure Using a Static Annealing Sulfurization Approach

In situ solvothermal growth of Cu2ZnSnS4 thin film for counter electrode of dye-sensitized solar cells

Optical and Electrical Properties Study of Sol-Gel Derived Cu2znsns4 Thin Films for Solar Cells

Structural, Electronic and Defect Properties of Cu<sub>2</sub>ZnSn(S,Se)<sub>4</sub> Alloys

Improved Performance of Electroplated CZTS Thin-Film Solar Cells with Bifacial Configuration

Reaction Time and Film Thickness Effects on Phase Formation and Optical Properties of Solution Processed Cu2ZnSnS4 Thin Films

Structural, Electronic and Defect Properties of Cu 2 ZnSn(S,Se) 4 Alloys

Phase composition of the earth-abundant Cu2SnS3 thin films with different annealing temperature and its effects on the performance of the related solar cells

Fabrication of solar cells based on $Cu_2ZnSnS_4$ prepared from $Cu_2SnS_3$ synthesized using a novel chemical procedure

Investigation of Cu2ZnSnS4 thin film with preannealing process and ZnS buffer layer prepared by magnetron sputtering deposition

Study on the Optimization of Cu-Zn-Sn-O to Prepare Cu2ZnSnS4 Thin Film via a Nano Ink Coating Method