Abstract:Science Progress, Volume 107, Issue 3, July-September 2024. Accurately measuring the mechanical properties of high-strength stainless steels is of great significance for ensuring structural safety, predicting long-term performance and optimizing design. However, the standardized tensile test specimens used to obtain strength properties must be fabricated from bulk materials from an in-service structure or component, result in the loss of structural integrity or a reduction in remaining service life. Small punch tests require only miniscule material samples and are widely used to estimate in-service component material characteristics. This study performed small punch tests on three high-strength stainless steels—X17CrNi15-2, 15-5PH, and PH13-8Mo—to obtain the correlations between the small punch tests and the uniaxial tensile test results for each material. The estimated yield stresses obtained from the small punch tests were distributed within a factor of 1.5 on both sides of the unity line when compared with those obtained from the uniaxial tensile tests; the ultimate strength values estimated from the small punch tests correlated quite well with those obtained from the uniaxial tensile tests. An iterative finite element analysis was subsequently established to simulate the small punch tests and thereby obtain the coefficients for a Ludwik power law correlation representing the true stress–strain properties. The finite element predicted force–deflection curves agreed well with the small punch test results, which were also compared with the predictions obtained from empirical equations proposed in previous studies. Finally, the fracture mechanisms of the small punch test specimens were characterized through scanning electron microscopy, indicating that the dimple fracture mechanism dominated the failure mode. The results of this study are expected to inform the application of small punch test to evaluate in-service high-strength stainless steel materials.

Mechanical Properties Estimation of Materials With Different Grain Sizes by Small Punch Test at Elevated Temperature

Assessment of Toughness in Long Term Service Crmo Low Alloy Steel by Fracture Toughness and Small Punch Test

Study on Mechanical Properties of S30403 Based on Small Punch Test Technique at Elevated Temperature

Investigation of fatigue mechanical properties of apolycrystalline solid at mesoscopic scale using depth-sensing indentation (DSI) technique

An Investigation of the Effect of High-Temperature Cyclic Straining and Creep Loading on Tensile Mechanical Properties of GH4145/SQ Alloy

Evaluation of effect of spheroidization heat treatment on mechanical properties via small punch test

Elastic and Plastic Deformation Behavior Analysis in Small Punch Test for Mechanical Properties Evaluation

Small Punch Evaluation of Mechanical Properties for 310S Stainless Steel Considering Pre-Strain Effect

Mechanical Properties Study of Miniature Steel Specimens Based on the Small Punch Test and Simulation Methods

Improved approaches for small punch test to estimate the yield and ultimate tensile strength of metallic materials

Study on Influence Factors of Small Punch Test Based on Ductile Damage Numerical Analysis

Investigation on the Tensile Properties of Inconel 625 Using Small Punch Test

Enhanced Mechanical Behaviors of Gradient Nano-Grained Austenite Stainless Steel by Means of Ultrasonic Impact Treatment

Experimental Characterization and Strengthening Mechanism of Process-Structure-property of Selective Laser Melted 316 L

Yield Strength Analysis by Small Punch Test Using Inverse Finite Element Method

Material damage evaluation and life prediction via small punch test technology

Evaluating the tensile properties of high-strength stainless steels using small punch testing

Fracture toughness estimation of ductile materials using a modified energy method of the small punch test

Study on Small Punch Creep Test for SUS304

Application of Small Punch Test to Investigate Mechanical Behaviours and Deformation Characteristics of Incoloy800H

A Study on Influence Factors of Small Punch Creep Test by Experimental Investigation and Finite Element Analysis