Abstract:Science Progress, Volume 107, Issue 3, July-September 2024. Accurately measuring the mechanical properties of high-strength stainless steels is of great significance for ensuring structural safety, predicting long-term performance and optimizing design. However, the standardized tensile test specimens used to obtain strength properties must be fabricated from bulk materials from an in-service structure or component, result in the loss of structural integrity or a reduction in remaining service life. Small punch tests require only miniscule material samples and are widely used to estimate in-service component material characteristics. This study performed small punch tests on three high-strength stainless steels—X17CrNi15-2, 15-5PH, and PH13-8Mo—to obtain the correlations between the small punch tests and the uniaxial tensile test results for each material. The estimated yield stresses obtained from the small punch tests were distributed within a factor of 1.5 on both sides of the unity line when compared with those obtained from the uniaxial tensile tests; the ultimate strength values estimated from the small punch tests correlated quite well with those obtained from the uniaxial tensile tests. An iterative finite element analysis was subsequently established to simulate the small punch tests and thereby obtain the coefficients for a Ludwik power law correlation representing the true stress–strain properties. The finite element predicted force–deflection curves agreed well with the small punch test results, which were also compared with the predictions obtained from empirical equations proposed in previous studies. Finally, the fracture mechanisms of the small punch test specimens were characterized through scanning electron microscopy, indicating that the dimple fracture mechanism dominated the failure mode. The results of this study are expected to inform the application of small punch test to evaluate in-service high-strength stainless steel materials.

Study on Mechanical Properties of S30403 Based on Small Punch Test Technique at Elevated Temperature

Mechanical Properties Estimation of Materials With Different Grain Sizes by Small Punch Test at Elevated Temperature

Study on yield strength of Q345R by energy method of small punch test

Improved approaches for small punch test to estimate the yield and ultimate tensile strength of metallic materials

Assessment of Toughness in Long Term Service Crmo Low Alloy Steel by Fracture Toughness and Small Punch Test

A new small punch test method to predict tensile properties of steels: Representative stress–strain method

Investigation of fatigue mechanical properties of apolycrystalline solid at mesoscopic scale using depth-sensing indentation (DSI) technique

Small Punch Evaluation of Mechanical Properties for 310S Stainless Steel Considering Pre-Strain Effect

Study on Small Punch Creep Test for SUS304

Variation In Mechanical Properties, Microstructures And Fracture Behavior Of 304 Stainless Steel During Low-Cycle Fatigue

EXPERIMENTAL RESEARCH ON IMPACT BEHAVIOR OF CONCRETE-FILLED STEEL TUBE AT ELEVATED TEMPERATURES

High-temperature mechanical properties evaluation of 310S stainless steel

Evaluating the tensile properties of high-strength stainless steels using small punch testing

Study on Influence Factors of Small Punch Test Based on Ductile Damage Numerical Analysis

Mechanical Properties Study of Miniature Steel Specimens Based on the Small Punch Test and Simulation Methods

Research and Application on Small Punch Test Technology

Investigation on the Tensile Properties of Inconel 625 Using Small Punch Test

Elastic and Plastic Deformation Behavior Analysis in Small Punch Test for Mechanical Properties Evaluation

Experimental investigation of cold-formed steel material at elevated temperatures

Deterioration of Mechanical Properties of Novel Constructional Steel Material at Elevated Temperatures

Dynamic behavior of SUS304 stainless steel at elevated temperatures