Abstract:Science Progress, Volume 107, Issue 3, July-September 2024. Accurately measuring the mechanical properties of high-strength stainless steels is of great significance for ensuring structural safety, predicting long-term performance and optimizing design. However, the standardized tensile test specimens used to obtain strength properties must be fabricated from bulk materials from an in-service structure or component, result in the loss of structural integrity or a reduction in remaining service life. Small punch tests require only miniscule material samples and are widely used to estimate in-service component material characteristics. This study performed small punch tests on three high-strength stainless steels—X17CrNi15-2, 15-5PH, and PH13-8Mo—to obtain the correlations between the small punch tests and the uniaxial tensile test results for each material. The estimated yield stresses obtained from the small punch tests were distributed within a factor of 1.5 on both sides of the unity line when compared with those obtained from the uniaxial tensile tests; the ultimate strength values estimated from the small punch tests correlated quite well with those obtained from the uniaxial tensile tests. An iterative finite element analysis was subsequently established to simulate the small punch tests and thereby obtain the coefficients for a Ludwik power law correlation representing the true stress–strain properties. The finite element predicted force–deflection curves agreed well with the small punch test results, which were also compared with the predictions obtained from empirical equations proposed in previous studies. Finally, the fracture mechanisms of the small punch test specimens were characterized through scanning electron microscopy, indicating that the dimple fracture mechanism dominated the failure mode. The results of this study are expected to inform the application of small punch test to evaluate in-service high-strength stainless steel materials.

Evaluating the tensile properties of high-strength stainless steels using small punch testing

Assessment of Toughness in Long Term Service Crmo Low Alloy Steel by Fracture Toughness and Small Punch Test

A new small punch test method to predict tensile properties of steels: Representative stress–strain method

Small Punch Evaluation of Mechanical Properties for 310S Stainless Steel Considering Pre-Strain Effect

Variation In Mechanical Properties, Microstructures And Fracture Behavior Of 304 Stainless Steel During Low-Cycle Fatigue

Use of instrumented indentation testing to study local mechanical properties of 304L SS welded joints subjected to low-cycle fatigue loadings

Validation and improvement in metallic material tensile models for small punch tests

Improved approaches for small punch test to estimate the yield and ultimate tensile strength of metallic materials

Investigation on the Tensile Properties of Inconel 625 Using Small Punch Test

Mechanical Properties Study of Miniature Steel Specimens Based on the Small Punch Test and Simulation Methods

Study on Mechanical Properties of S30403 Based on Small Punch Test Technique at Elevated Temperature

An improved analysis of small punch deformation for evaluating tensile properties

Small Punch Testing of a Ti6Al4V Titanium Alloy and Simulations under Different Stress Triaxialities

Application of 3D digital image correlation for the measurement of the tensile mechanical properties of high-strength steel

Elastic and Plastic Deformation Behavior Analysis in Small Punch Test for Mechanical Properties Evaluation

A review of selected small specimen test techniques for identifying deformation and failure properties of metallic materials

Quantitative analysis of strength and plasticity of a 304 stainless steel based on the stress-strain curve

Study on Influence Factors of Small Punch Test Based on Ductile Damage Numerical Analysis

On the estimation of tensile yield stress for polymer materials based on punch tests

Mechanical Properties Estimation of Materials With Different Grain Sizes by Small Punch Test at Elevated Temperature

Finite element analysis of locally strengthened stainless-steel tube under lateral impact loading