Study on Small Punch Creep Test for SUS304

Chen Yu-Xin,LING Xiang,TU Shan-tong

DOI: https://doi.org/10.3969/j.issn.1001-4888.2005.02.010

2005-01-01

Abstract:Small punch creep test technique (SPC) using miniature specimen is a new technique which is applied to evaluate the creep properties of materials in high temperature nearly non-destructively. SPC has been applied to evaluate the creep property of SUS 304 stainless steel at different temperature and load range of 443N~513N. A series of deflection curves under different conditions were obtained. Then, the deformation of specimens during the test was analyzed through observing the interrupted specimens by scanning electron micrograph. Also, the major factors influencing the test are discussed. The test results showed that the creep curves, determined by means of the small punch creep test, are similar to those obtained from a conventional uniaxial creep test. That is, they exhibited clearly three creep stages. The specimen central initial deflection and the creep rate of secondary stage increased with an increase of test load level, while the rupture time decreased. Load, temperature, thickness of specimen and environment are the major factors influencing the test.