Abstract:Plasma-enhanced atomic layer deposition (PE-ALD) is widely employed in microelectronics, energy, and sensing applications. Typically, PE-ALD processes for metal oxides utilize remote inductively coupled plasmas operated at powers of >200 W, ensuring a sufficient flux of oxygen radicals to the growth surface. However, this approach often leads to significant oxidation of chemically sensitive substrates, including most technological semiconductors. Here, we demonstrate that plasma powers as low as 5 W can effectively suppress substrate oxidation while maintaining the structural, optical, and electronic quality of the films. Specifically, we investigate the growth of titanium oxide (TiOx) using two commonly used metalorganic precursors, titanium isopropoxide and tetrakis(dimethylamino)titanium. Films deposited with 5 and 300 W oxygen plasma power are nearly indiscernible from one another, exhibiting significantly lower defect concentrations than those obtained from thermal ALD with H2O. The low plasma power process preserves desired physical characteristics of PE-ALD films, including large optical constants (n > 2.45 at 589 nm), negligible defect-induced sub-bandgap optical absorption (α < 102 cm−1), and high electrical resistivity (>105 Ω cm). Similar behavior, including suppressed interface oxidation and low defect content, is observed on both Si and InP substrates. As an example application of this approach, the assessment of InP/TiOx photocathodes and Si/TiOx photoanodes reveals a significant improvement in the photocurrent onset potential in both cases, enabled by suppressed substrate oxidation during low power PE-ALD. Overall, low power PE-ALD represents a generally applicable strategy for producing high quality metal oxide thin films while minimizing detrimental substrate reactions.

Some Oxide-Films Deposited By Reactive Low-Voltage Plasma-Assisted Evaporation

Optical-Electric Thin Films Produced By Low Voltage Reactive Plasma Assisted Deposition

Study on the optical thin film deposited by plasma ion plating

Advances in Research on Deposition Techniques for ZnO Thin Films

SEM Research of SiO2 Thin Film on Inner Wall of Glass Container by PECVD

A Mechanism for the Growth of a Plasma Electrolytic Oxide Coating on Al

Non-equilibrium,Atmospheric-pressure Plasma Jet for Depositing Silicon Oxide Films

Plasma-activated high rate evaporation using a low voltage electron beam system

The Power Source Effect on SiOx Coating Deposition by Plasma Enhanced Chemical Vapor Deposition

Low Voltage Ion Plating Technique for the Deposition of ZnS, MgF2 Films

Properties and Mechanism of PEALD-In2O3 Thin Films Prepared by Different Precursor Reaction Energy

Electrodeposited Thin Oxide Films

Structural and Optical Characterizations of ZnO Films Grown by Reactive Electron Beam Evaporation

Recent Development of Low-Voltage Reactive-Ion-plating Deposition of Optical Thin Films in China

Plasma-enhanced pulsed laser deposition of copper oxide and zinc oxide thin films

Optical Properties of Thin Oxide Films Produced by Energetic Ion Beams

Preparation and characterization of the low-energy plasma electrolysis oxide coatings on Mg Li alloy

Principle and Applications of Plasma Enhanced Atomic Layer Deposition

Characteristics of a Source for Oxide Coating Deposition by the Electron-Beam Evaporation of Dielectric Materials

Suppressing substrate oxidation during plasma-enhanced atomic layer deposition on semiconductor surfaces

Matrix-Assisted Pulsed Laser Evaporation of Polyimide Thin Films and the Xps Study