Abstract:ABS particles with core-shell structure and nano-CaCO3, particles were employed to modify hard PVC simultaneously. The phase morphology and fracture behavior of the composites were investigated by means of transmission electron microscope (TEM), scanning electron microscope (SEM) and mechanical tests. Based on reasonable assumptions and material parameters obtained by the true stress-strain curve, finite element simulation employing the two-dimensional representative volume element model was carried out to explore the effects of ABS and CaCO3 particles on the fracture behavior of the composites. Results showed that ABS and CaCO3 particles have a synergistic toughening effect at nano-CaCO3 contents lower than 12 phr. The TEM observation revealed that the ABS particles deformed mainly by cavitation rather than interfacial debonding. The finite element analysis (FEA) results indicated that the blend yields when local yielding areas in the matrix begin to interconnect throughout the interstitial matrix between the particles. The predicted yield stresses for the PVC/ABS binary blend and the PVC/ABS/nano-CaCO3 ternary composite are consistent with experimental values. Moreover, the FEA results implied that both ABS and CaCO3 particles could toughen the PVC matrix, and the well-dispersed CaCO3 particles had a better toughening effect. If the CaCO3 particles are agglomerated,however, the large crevices between CaCO3 agglomerates and PVC matrix would initiate cracks at the interface and lead to decrease of mechanical properties.

Effect of Morphology on Crack Extension Property of PC/ABS Polymer Alloy.

Tensile and Fracture Behaviors of Pc/Abs Polymer Alloy

Morphology on ABS and PC/ABS Series of Polymer Alloy Influence on Mechanical Properties

Effect of Triaxial Stress Constraint on the Deformation and Fracture of Polymers

FATIGUE CRACK GROWTH BEHAVIOR OF PC AND PC/ABS

Effect of cyclic loading on tensile properties of PC and PC/ABS

Experimental Investigation of the Low Cycle Fatigue Crack Propagation in Pc/Abs Polymer Blends

Experimental Investigation on the Essential Work of Mixed-Mode Fracture of PC/ABS Alloy

Investigation on the Tensile Property of Pc/Abs Polymer

Phase Morphology Evolvement and Properties of High Flowability PC/ABS Alloy

Morphology and mechanical properties of Acrylonitrile-styrene-acrylate toughened plastics with block copolymer chain structure: Acrylonitrile-styrene-acrylate (ASA) toughened plastics with block copolymer chain structure

Large tensile deformation behavior of PC/ABS alloy

Morphology and Mechanical Behaviors of Rigid Organic Particles Reinforced Polycarbonate

Investigation of Toughening Mechanisms in Elastomeric Polycarbonate Blends through Morphological and Mechanical Characterization at Small and Medium Strain Rates

EFFECT OF RUBBER AND INORGANIC RIGID PARTICLES ON FRACTURE BEHAVIOR OF INJECTION-MOLDED PVC NANOCOMPOSITES

Comparison of the Tensile Performance of Polymer PC and PC/ABS

‘Tail’ phenomenon and fatigue crack propagation of PC/ABS alloy

Deformation Response and Constitutive Modeling of PC, ABS and PC/ABS Alloys under Impact Tensile Loading

Fracture Toughness of PC and PC/ABS Alloy

Effect of Interface on Brittle - Ductile Transition and Fracture Behavior of ABS/PA6 Blends

Numerical simulation of tensile performance of polymers