Abstract:γ-ray radiation effect on sol-gel silica films was investigated at different absorbed doses ranging from 10 kGy to 1000 kGy. The defect and microstructure evolutions of silica films were analyzed to understand the performance degradation behavior and mechanism of the γ-ray irradiated silica films. The cracks appear on the silica film surface and further expand at larger γ-ray absorbed dose, while surface roughness slightly decreases. During γ-ray irradiation, the thermal effect and the increased rate of diffusion-controlled process lead to the condensation of Si-OH groups and the recombination of ODCs. However, the ionization of atoms leads to generation and accumulation of E′ centers and NBOHCs. γ-ray irradiation leads to the reductions of bond lengths and bond angles of Si-O-Si groups, thus causing the densification of films. The refractive index and mechanical property firstly enhance and then reduce with the increase of absorbed dose associated with the change of silica film density. After γ-ray irradiation, the decreased contact angle and increased surface free energy indicate the reduction of anti-pollution ability of silica films. The dose-dependent surface quality, defects and mechanical properties determine the variation in laser-induced damage threshold (LIDT) of silica film. The results provide a reference to control the structural damage and performance degradation of silica films, which is very important for the research of safe operation of high-power laser facilities for inertial confinement fusion (ICF).

Comparison of the Damage Features of the Silica Films Prepared by the Sol-Gel and E-Beam Deposition Methods

Laser-Induced Damage on Ordered and Amorphous Sol-Gel Silica Coatings

Laser-induced damage mechanism of the sol–gel single-layer SiO2 acid and base thin films

Laser-induced Damage of Sol-Gel Silica Acid and Basic Thin Films

Effects of CO2 Laser Irradiation on Surface Morphology and Stress Distribution of Fused Silica

Ultraviolet Laser-Induced Damage on Fused Silica Substrate and Its Sol-Gel Coating.

Experimental Research of Laser-Induced Damage Mechanism of the Sol-Gel SiO2 and IBSD SiO2 Thin Films

Characteristics of laser-densified and conventionally heat treated sol–gel derived silica–titania films

Performance degradation mechanism of γ-ray irradiated sol-gel silica film

Contrast Study of Laser-induced Damage of Monolayer SiO2 and ZrO2 Films

Comparison of Laser-Induced Damage of Monolayer ZrO2 Films Preparated by PVD and Sol-Gel Methods

Optical Properties and Laser Damage Performance of Sio2 Irradiated by High-Power Pulsed Electron Beam

Damage Behaviors of Silica Microparticles on Fused Silica Optics under 355 Nm High Fluence Laser

Laser Induced Damage Characteristics of Fused Silica Optics Treated by Wet Chemical Processes

Surface Damage Mitigation of Fused Silica with CO2 Laser

Laser Damage Induced by Contamination Particles on Coated Optical Components

Comparision of Silica Anti-Reflective Films Obtained Via a Sol-Gel Process in the Presence of PEG or PVP

Surface Evolution and Laser Damage Resistance of CO2 Laser Irradiated Area of Fused Silica

Investigation of Stress Wave and Damage Morphology Growth Generated by Laser-Induced Damage on Rear Surface of Fused Silica.

Investigation of surface characteristics evolution and laser damage performance of fused silica during ion-beam sputtering

Comparison of surface damage under the dry and wet impact: Molecular dynamics simulation