Abstract:Multi-channel wire electrical discharge machining (WEDM) is widely used for slicing semiconductor materials and improving cutting rate through multi-channel discharge. However, enhancing the cutting rate of integral metal workpieces through the utilization of multi-channel WEDM remains a challenge. This paper investigated the discharge characteristics of metal workpiece using multi-channel high-speed WEDM (HSWEDM). It was discovered that due to the high conductivity of the metal workpiece, there is electrical signal coupling between each channel, which inhibits the independent discharge of each channel and severely impacts the improvement of cutting rate. To solve this problem, a new power supply with a decoupled circuit was designed, and the potential difference between adjacent channels was formed by using a current-limited resistor at each output, reducing coupling between the channels and enabling independent discharges at each channel, thereby improving the cutting rate of metal materials. The effect of current-limited resistance ( R c ) on multi-channel synchronous discharges was analyzed through online acquisition of discharge signals, demonstrating that reducing the R c can improve the discharge ratio. In the two-channel HSWEDM with the new power supply, when the R c is reduced from 15 to 5/3 Ω, the gap voltage is increased from 31 to 64 V, the discharge ratio is increased from 0.967 to 1.566, and the increase in cutting rate was from 19.06% to 83.02%. Furthermore, when R c is 5/2 Ω, the cutting rate was 1.660–1.971 times that of conventional power supply. Since each channel can implement independent servo control after electrical signal decoupling, the dimensional uniformity and surface topography of grooves are improved, and the thickness of the recast layer is reduced. Lastly, the new power supply was applied to the four-channel HSWEDM, resulting in a significant increase in cutting rate, which was 3.538 times higher than that of conventional power supply.

Simulation on Influence of Electrostatic Force on Machining Characteristics in WEDM

Modeling and Simulation of Wire Electrode Deflection in WEDM

High Precision Simulation of Wedm Using Parametric Programming

Influence of Discharge Current on Machined Surfaces by Thermo-Analysis in Finish Cut of WEDM

Influence of Machining Parameters on Surface Roughness in Finish Cut of WEDM

Three-dimensional characteristics analysis of the wire-tool vibration considering spatial temperature field and electromagnetic field in WEDM

Study on Magnetic Field Distribution and Electro-Magnetic Deformation in Wire Electrical Discharge Machining Sharp Corner Workpiece

Thermo-mechanical analysis and optimal tension control of micro wire electrode

Experimental Determination of Convective Heat Transfer Coefficient in WEDM

Investigating the influence of rotational speed in wire electric discharge machining of cylindrical workpieces: an experimental and simulation study

Gap status identification and control of wire electrochemical micromachining

Corner error simulation of rough cutting in wire EDM

Improvement of the Machining Characteristics in WEDM Based on Specific Discharge Energy and Magnetic Field–assisted Method

Research on machining Technology of Electrospark-electrochemical Hybrid Energy Field with tungsten hole

3D Transient Thermal Analysis of Wire Electrode under Consecutive Discharges

A Macroscopic Mechanical Model of Wire Electrode Deflection Considering Temperature Increment in MS-WEDM Process

Measurement of Wire Electrode Temperature in WEDM

Investigation on a Novel Surface Microstructure Wire Electrode for Improving Machining Efficiency and Surface Quality in WEDM

3D Simulation of the Flow Field in the Machining Gap during EDM

Machining of Micro-electrode Array by WEDM

Study on discharge characteristics and process of multi-channel high-speed wire electrical discharge machining for metal workpieces