Abstract:The thermal barrier coatings have been widely used on hot components of aircraft and power generation gas engines, which lower the temperature of substrates and prolong operating life time and make the hot components work under higher temperature gas environment to improve efficiency as well. In order to ensure the reliability and security during the engine working, it is important to investigate mechanical parameters, material constitutive and microscopic morphological characteristics of TBCs, which affect the deformation analysis even the life time prediction of hot components in different extent. The atmospheric plasma sprayed thermal barrier coating was focused on in this work. For sprayed process in our country, the material parameters of top coat are not measured. Using resonant frequency method and laminated plate theory, the Young's modulus of APS-TBCs were obtained from room temperature to 1150 degrees C. The two-dimensional symmetric finite element models of tube were established with MSC.MARC. Thermal grow oxidation layer between top coat and bond coat was modeled with a sinusoidal geometry in different dimension and a thickness of 2, 4, 6 and 8 pm respectively. The thermal stress contributions in TBCs were calculated under thermal cycle condition using Young's modulus determined from this work and the references respectively. Thermal fatigue load was cycled over a range from 100 degrees C to 1050 degrees C for 5 times. The ideal linear elastic model and viscoplastic model were selected to simulate the behavior of top coat. The results shown that there are great differences in the stress field of top coat because of different Young's modulus, material constitutive model and characteristics of TGO. The simulation results offered data to select appropriate material parameters, characteristics of TGO, and constitutive model for the stress analysis and life time prediction of hot components in the future.

Microstructural and Mechanical Properties of Thermal Barrier Coating at 1400°C Treatment

Effect of Heat Treatment at 900 °C on Microstructural and Mechanical Properties of Thermal Barrier Coatings

Physical and mechanical properties of plasma-sprayed thermal barrier coatings at room and high temperatures

Effect of Thermal Exposure on Mechanical Properties of a Plasma-Sprayed Nanostructured Thermal Barrier Coating

Microcracks characterization for thermal barrier coatings at high temperature

Sintering and Failure Behaviour of Eb-Pvd Thermal Barrier Coating after Isothermal Treatment

Experimental Study of the Thermally Grown Oxide and Interface of Thermal Barrier Coatings Using TEM In-Situ Heating

Thermal cycle behavior of atmospheric plasma sprayed thermal barrier coatings

Effect of porous microstructure on the elastic modulus of plasma-sprayed thermal barrier coatings: Experiment and numerical analysis

High Temperature Hardness and Thermal Analysis of CoNiCrAlY Alloys Used As Bond Coats for Thermal Barrier Coatings

Microstructural evolution of plasma spray physical vapor deposited thermal barrier coatings at 1150 °C studied by impedance spectroscopy

Effect of the Microstructural Design of Plasma-Sprayed Thermal Barrier Coatings on Its the Thermal Cycling Behaviour

Effects of Heat Treatment on Microstructures and Physical Properties of Segmented Thermal Barrier Coatings

Effect of long-term heat-treatment at 1150 °C on the microstructure and properties of thermal barrier coatings based on ZrO2–4 mol.% Y2O3–1 mol.% Gd2O3–1 mol.% Yb2O3

Microstructural Evolution and Failure Mechanisms of Thermal Barrier Coatings under Extreme Environmental Conditions

Thermophysical properties and thermal cycling behavior of plasma sprayed thick thermal barrier coatings

Sintering resistance of advanced plasma-sprayed thermal barrier coatings with strain-tolerant microstructures

Investigating the Cmas Corrosion Resistance and Thermal Cycling Failure Behavior of Porous Thermal Barrier Coatings with Different Morphologies Prepared by Plasma Spraying

Thermal Fatigue of Atmospheric Plasma Sprayed Thermal Barrier Coatings

Oxidation Damage of APS Thermal Barrier Coatings under High Temperature

Microstructure characteristics and deformation-induced crystalline-to-amorphous phase transformation in thermal barrier coatings during thermal cycling