Abstract:With the integrated circuit and semiconductor industry develop rapidly, the traditional flat package can't meet the demands for higher performance and lower cost requirements for handheld and portable electronic devices any more in the semiconductor industry. The 3D stacked package technology is a developing method to fit the integrated circuit advanced high-density packaging, which can easily meet the requirement of smaller footprint, thinner profile, multi-function, lower power consumption and lower cost for the smart phones and consumer electronic products. The 3D flexible stack package is a new kind of 3D package which uses special surface metal layer to achieve the interconnection of different dies in the 3D package. The 3D flexible stock package has many advantages over other 3D package (like TSV, FC, etc.). It can achieve the interconnnection between different kinds of functional dies by putting the chip on a flexible substrate to redesign the circuit. Besides, the 3D flexible package can also simplify the packaging process and reduce the production cost. According to these advantages, the 3D flexible can be applied in the field of aerospace and military. The main process of the 3D package is to film the metal layer on a plastic packaging cube by surface treatment technology. Electroless plating (EP) is a better chioce, but for now, EP on the plastic material is not enough mature. The binding force of the plating layer on plastic is not able to be guaranteed. In this paper, the results showed the pretreatment process of electroless plating and the plating environment are the important influence factors to the plating results. By the way of designing contrast test to find the right parameters, like the surface roughness, temperature, is the main method to solve the problems. Although the EP nickle layer can be successfully coated on the surface of plastic cube, the plating effect (the binding force, thickness, thermostability, etc.) can't be made sure. Therefore finding a suited method to test the performance of the nickel coat is also of great importance. This paper primarily focused on the way of the eletroless plating nickle and the method of the coat performance examination, and obtaining some useful technological parameters and reliability data by comparing the experimental results.

A Study To Performance Of Electroplating Solder Bump In Assembly

A Study to Stencil Printing Technology for Solder Bump Assembly

Efficiency analysis of electroplating gold bump in assembly

Method to Improve the Process Efficiency for Copper Pillar Electroplating

The Research on a Low Cost Flip Chip Bumping Process by Stencil Printing

Design of Laser Scanning Solder,Bumping System

Laser Ink-Jet Solder Bump Fabrication for Electronic Interconnection

Study of Stencil Printing Technology for Fine Pitch Flip Chip Bumping

The Study on the Shaping of Electroplated Copper Pillar Bumping

Characterization of stencil printing parameters for fine pitch wafer bumping

Electroless Deposition of Nickel Microbumps for Fine-Pith Flip-Chip Bonding

Research of gold bump for wafer level package

Formation of SnAg Solder Bump by Multilayer Electroplating

Characterization of sintered Cu nanopaste for micro-bumping with Injection Molded Solder technology

Fine Pitch and High Density Sn Bump Fabrication

23‐2: Invited Paper: Fabrication of Super Uniform Nickel Bumps Using Electroless Plating on Micro‐LEDs’ TFT Driver Substrates

Influence of Under-Bump Metallurgy and Solder Alloys on the Crack in the Wafer Level Chip Scale Packaging

A Study on Improvement and Extension of Fine-Pitch Micro-Bump Interconnects Technology: New Metallurgy & Flux-Less Oxide-removal Laser Assembly (FLOLA)

Lead-Free Bumping Using an Alternating Electromagnetic Field

Study of Surface Metallization on 3D Flexible Stack Package

Laser-Assisted Micro-Solder Bumping for Copper and Nickel-Gold Pad Finish