Abstract:Reducing production cost to accelerate the industrialization process of thin film solar cells (TFSCs) makes it urgently demanded to elevate the deposition rate and reduce the needed thickness of absorbers in addition to the prerequisite performance improvement. Based on very high frequency plasma enhanced chemical vapor deposition process with a low bombardment energy and large ion flux, ultra-thin, high-deposition-rate, and high-performing hydrogenated microcrystalline silicon (c-Si:H) single- and related hydrogenated amorphous silicon (a-Si:H)/c-Si:H double-junction TFSCs are developed in this study. By tuning various process parameters (silane concentration, power, and pressure), the deposition rates and electrical properties of c-Si:H materials are studied in detail. Device-level c-Si:H intrinsic materials with a deposition rate of 10.57 /s and photosensitivity of 7.54102 can be obtained when depositing with a silane concentration of 9%, a power of 70 W, and a pressure of 2.5 Torr. By further applying device-level high-deposition-rate c-Si:H intrinsic materials in c-Si:H single-junction TFSCs on magnetron-sputtered and wet-etched aluminum-doped zinc oxide (ZnO:Al) substrates with optimized surface morphologies and photoelectrical properties, and by combining advanced device designs, an initial conversion efficiency of 7.49% can be achieved for pin-type ultra-thin and high-deposition-rate c-Si:H single-junction TFSCs (the thickness values of intrinsic layers are 1.1~m). To further improve the conversion efficiency of TFSCs, pin-type a-Si:H/c-Si:H tandem TFSCs are fabricated by using n-a-Si/n-c-Si/n-nc-SiOx:H/p-nc-SiOx:H as the tunnel recombination junctions (TRJs), which, however, have unaddressed issues that the wide band-gap nc-SiOx:H materials with a low conductivity strongly reduce the recombination rate of carriers, thereby resulting in the photo-generated carriers accumulating near the TRJs, weakening the built-in electric field in the top sub-cells and leading to an open circuit voltage (Voc) loss in a-Si:H/c-Si:H tandem TFSCs up to 115~mV far above average values. By simultaneously inserting the p- and n-type narrow-gap c-Si:H materials, which are highly defective and narrower than the band gap of nc-SiOx:H materials, into the TRJs to implement the electrically lossless interconnection between the a-Si:H top and c-Si:H bottom sub-cells, the Voc loss is successfully reduced to 43~mV and an initial efficiency of 12.03% (Voc=1.48~eV, Jsc=11.67~mA/cm2, FF=69.59%) is achieved for ultra-thin pin-type a-Si:H/c-Si:H tandem TFSCs with a total thickness of 1.48~m, thus paving the way for the low-cost production of TFSCs.

Triple-Functional N-Type Microcrystalline Silicon Oxide Layers in Hydrogenated Amorphous Silicon/Microcrystalline Silicon Tandem Solar Cells

Nanocrystalline silicon-oxygen based tunneling recombination junctions in perovskite/silicon heterojunction tandem solar cells

The Study of a New N/p Tunnel Recombination Junction and Its Application in A-Si:H/μc-si:h Tandem Solar Cells

Crystalline Silicon Heterojunction Solar Cells with Metal Oxide Window Layers

High efficiency triple junction thin film silicon solar cells with optimized electrical structure

The P Recombination Layer in Tunnel Junctions for Micromorph Tandem Solar Cells

Silicon-nanocrystal-incorporated Ternary Hybrid Solar Cells

Quadruple-Junction Thin-Film Silicon Solar Cells Using Four Different Absorber Materials

Optimum Design And Preparation Of A-Si/A-Si/A-Sige Triple-Junction Solar-Cells

Bathocuproine:Ag Complex Functionalized Tunneling Junction for Efficient Monolithic Perovskite/TOPCon Silicon Tandem Solar Cell

A-Si ∶H/a-Si ∶H/μc-Si ∶H Triple Junction Solar Cells

Ultra-Thin Film Microcrystalline Silicon with High Deposition Rate and Its Application in Tandem Silicon Solar Cells

Optimum design and preparation of<i>a</i>‐Si/<i>a</i>‐Si/<i>a</i>‐SiGe triple‐junction solar cells

Fabrication of PIN Triple-Junction Si-based Thin Film Solar Cells Incorporating Microcrystalline Silicon As Bottom Cell

Beyond 25% efficient crystalline silicon heterojunction solar cells with hydrogenated amorphous silicon oxide stacked passivation layers for rear emitter

Improved Interface Microstructure Between Crystalline Silicon and Nanocrystalline Silicon Oxide Window Layer of Silicon Heterojunction Solar Cells

Molecular Synergistic Effect for High Efficiency Monolithic Perovskite/Perovskite/Silicon Triple‐Junction Tandem Solar Cells

Highly transparent modulated surface textured front electrodes for high‐efficiency multijunction thin‐film silicon solar cells

Triple-junction hybrid tandem solar cells with amorphous silicon and polymer-fullerene blends

Improved V 2 O X Passivating Contact for p ‐Type Crystalline Silicon Solar Cells by Oxygen Vacancy Modulation with a SiO X Tunnel Layer

Quadruple-junction thin-film silicon-based solar cells with high open-circuit voltage