Abstract:Low-cycle fatigue (LCF) behavior of nickel-based precipitation-strengthened superalloy GH4145/SQ was investigated systematically under fully reversed total strain amplitude control conditions at 538°C in laboratory air. It was shown that the alloy exhibited a pronounced initial fatigue hardening followed by continuous fatigue softening to failure at high strain amplitudes, while at low strain amplitudes the initial hardening was followed by a well-defined saturation stage. Microstructure observations using optical and transmission-electron microscopy revealed that slip band density increased with increasing total strain amplitudes and the size of the γ′precipitates tended to reduction due to repeated shearing by the dislocations with continuous cyclic straining. The above changes in microstructures during cycling were essentially responsible for the fatigue hardening–softening behavior of the alloy. Both optical and SEM micrographs indicated that at low strain amplitudes crack propagation was basically transgranular, while at high strain amplitudes crack propagation was essentially intergranular. Bilinear behavior with a change of slope at a plastic strain amplitude of about 0.2pct was observed in cyclic stress–strain (CSS), Coffin–Manson (C–M) and plastic strain energy–life plots. A change in the number of operating slip systems and the fracture modes with the strain amplitude employed was used to explain this two-slope characteristic. In both the companion specimens test (CST) and the incremental step test (IST) methods the alloy exhibited non-masing type behavior. It was suggested that, for the first approximation, the half-life plastic strain energy could be calculated directly according to the equation without reckoning in the non-masing behavior.

The Strain Amplitude-Controlled Cyclic Fatigue Behavior of Al2O3 Fiber Reinforced Al–Si Alloy Composite at Elevated Temperatures

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Effect of cyclic straining at elevated-temperature on static mechanical properties, microstructures and fracture behavior of nickel-based superalloy GH4145/SQ

Influence of Strain Amplitude on Low-Cycle Fatigue Behaviors of a Fourth-Generation Ni-Based Single-Crystal Superalloy at 980 °C

Hot dwell-fatigue behaviour of additively manufactured AlSi10Mg alloy: Relaxation, cyclic softening and fracture mechanisms

Compressive deformation behavior of α-Si3N 4w/4032 Al composite at elevated temperatures

Low cycle fatigue response and fracture mechanism in a novel Al-3.5Si-0.5Mg-0.4Cu casting alloy

Effect of Fiber Volume Fraction on Low Cycle Fatigue Behavior of Al<sub>2</sub>O<sub>3f</sub>/Al-Si Composites

High temperature compression behavior of Al2O3 particle reinforced 6061aluminum alloy composite

Effect of Fiber Volume Fraction on Low Cycle Fatigue Behavior of Al2o3f/Al-Si Composites

High fatigue performance and microscopic mechanisms of in-situ TiB 2 /7050Al composite at different temperatures

Low-cycle Fatigue Behavior and Damage Progression of a Fiber Reinforced Titanium Matrix Composite

Al/Al2O3 composite mechanical behaviour of compression in pseudo-semi-solid sate

Tensile and Fatigue Response of Alumina-Fiber-Reinforced Aluminum Matrix Composite

High Temperature Mechanical Behavior and Microstructure of α-Si 3N4w/4032Al Composite Fabricated by Squeeze Casting

Hot Compressive Deformation Behavior of a Eutectic Al–Si Alloy Based Composite Reinforced with Α-Si3n4 Whisker

Strength and Fatigue Properties of SiC Particle-Reinforced AC4C Based Aluminum Alloy Composites Fabricated by Melt Stirring-Gravity Casting

Thermo-Mechanical Fatigue Behavior and Resultant Microstructure Evolution in Al-Si 319 and 356 Cast Alloys

Compressive deformation behavior of alpha-Si(3)N(4)w/4032 Al composite at elevated temperatures

Influence of Strain Rate and Temperature on the Compressive Deformation of a Eutectic Al-Si Alloy Based Composite Reinforced with -Si3n4 Whisker

High-temperature, low-cycle fatigue behavior of an Al-Mg-Si based heat-resistant aluminum alloy